Search:

The night before charger showed green on all batteries. After I woke it up the battery had no capacity. Checked it today and it’s at 99% charge.

I will let you k on how it goes plan on giving it...

I have 3 of the 12 volt 50 ah batteries. I did not run at 100%. I ran the trolling motor this morning and it ran fine.

this happened when in the wind on anchor. I was in the same spot from 7am to...

I am running ionic batteries for trolling motor. Yesterday about 3 hours into fishing my trolling motor stopped working. I checked the ionic app and 1 of the trolling motor batteries was missing. I...

At that cost will dual 12 inch birds, 10 inch bird, 360, dual talons, LEDs, and all the pumps run on this all day with limited big motor running. I cover a lot of area verses spot hopping.

Need some help with decision.

The last 2 tournaments I lost ability to crank my motor. I have 2 Group 27 cranking batteries running in parallel. Was find for the past 2 years.

With the...

Has anyone found a switch that you can link to your Talons to remotely turn on and off the work light. I know the Smarphone App can do this but i dont always have my phone on me when i want to turn...

Any more updates

any updates on the outcome of the motor going up to 9 dots?

I am seeing everything that is offered even boost pressure which i did not know was a thing. I am not seeing water pressure but i could by pulling the cable off the gauge on the dash and getting it...

Below is the solution that has my unit working - hope this helps someone

My boat 2020 zx 225
Helix 12’s

Equipment needed for my setup
Humminbird network hub
NEMA black box from humminbird...

Solution to my problem - hope it helps someone else -
My boat 2020 zx 225
Helix 12’s

Equipment needed for my setup
Humminbird network hub
NEMA black box from humminbird
NEMA starter kit...

I added the battery to the cranking battery in parallel (+ to + and and the charger will charge across both batteries. Been running this setup for along time with no issues. Enable GingerCannot...

I have ZX225 with 2 units on the bow and a 15 foot was just right with a little slack on each end.

Thank you. I had a single unit till last week when I put the 10
on figured it would be better to run separately.

thanks for the help.

Would you recommend networking both bow units and using the Y cable to connect both units to the 12 and have the 10 pull 2d and DI across the network?

I have searched but cannot find that answer to my question.

Boat Setup -
Bow - Helix 12 Chirp Mega SI+ GPS G3N - Connected to Mega 360 only no network not Y cables
Bow - Helix 10 Chirp SI GPS...

Thank you.

Transducer in the Ultrex I think is the mega DI but it may be the universal. The ultrex was installed from factory which i think is the Ultrex 112/MDI/IP Link-45"_BT (inc HB Network box) The Helix...

I will be installing my second head unit on the Bow soon. Should i use the transducer in the Ultrex or should i install the SI transducer that came with the head Unit.

Current configuration is...

Thanks for the info.

I am getting ready to mount my second graph to the bow. I have a Helix 12 and will be adding a Helix 10 with Mega 360 and Ultrex built in transducer. What mount is the best. My boat is a 2020...

I installed mine in the corners as well and ran the wires into the holes in the side compartments to tap into the compartment lights. I was able to install all lights with out drilling any holes. ...

I did not do the install but had it done at the dealer after I purchased the boat and fished 2 long tournaments and had to jump off on both. I had them move the 3 Trolling motor batteries to the...

I am already running 5 group 27 batteries. First full day tourney I had in the boat I had to jump the motor. Installed another group 27, I Know lots of people say they can run on Group 31 but i had...

screen size 7 to 10 (10 would be nice)