still fighting this problem. turns out my dash gauge is a 90-0 ohm reading gauge,while todays standard is a 240-33 ohm sending units, kinda at a stand still because i really dont want to change the...
Type: Posts; User: 185er
still fighting this problem. turns out my dash gauge is a 90-0 ohm reading gauge,while todays standard is a 240-33 ohm sending units, kinda at a stand still because i really dont want to change the...
:thumb up2:
1997 hydrasport 185er need gas tank sending unit, belived to be 37 gal. tank 8341-75 f96 stamped on the unit. anyone had to replace theirs and where should i look? thanks in advance.
pm sent
if you decide to remove upper ram pin to clean and grease, again lower motor on trailering bracket remove retaining clip on each side and and tap pin out with punch,unit will tilt back enough you...
do as seahorse stated,also move engine up and down multiple times, during your day to remove any air that may still be trapped, this was what i did and then it sounded as it did new
let us know what you find.
another note to add,orings for manuel release valve didnt come in complete rebuild kit. i purchased the complete valve #0435340
had this same problem last year on my 150, found it to be a oring cracked on the manuel release screw. i lowered engine on motor toter,removed snap ring, screw unit out and replaced oring. may need...
not to be a nah sayer,,,,by your picture serious trouble lies ahead, be sure you carry tow rope along. if if were me i would have looked at asap in order to salvage any parts.
found a new one and ordered yesterday thanks everyone
looking to purchase new helix 10 chirp DI-GPS 4th gen,,,,havent been able to locate. any help if anyone that has saw any at their local sporting goods,marine sales are advice where to look. have...
never had a problem with warranty coverage from dobyns,always taken care of me.
had this problem when i built my house,new hot water heater but the pressure relief valve was defective, replaced and no problem since.
what years and engine sizes will complete tilt/trim unit interchange with my 1997 egleue
very possibly gonna have to replace my complete tilt/trim unit on my 97 evinrude intruder. anyone have a good used unit off of blown motor and selling parts? pm what you have and price please, and...
thats all good,,,,wish i knew how to post video
tilt tube nut tight and greased tilt tube zerks,,,,,problem persist,,,, another thing i notice when in reverse on water,unless gas pedal is feathered, motor kicks up to a degree. any relation to my...
1997 evinrude intruder gleue model bucking violently at end of tilting down prior to trimming position,trim is fine up and down,tilt is fine going up but down last say 1/2 inch is violent,,,,,thanks...
:thumb up2:
52" hustler raptor, kawasaki motor,been cutting 6 years with it now,about to put my first set of blades on it,,cut 2 acres and have no mercy with it,,,,its a tank
been there done that,,,,,
:thumb up2:
:thumb up2:
need only box will not need power cord nor transducer,this is for a gen2 units. mine has power and ground but box has stopped lighting up when powered on. please pm me with what you have and price...