Yes, everything works as it should, other than the spotlock problem. I have adjusted the boat scale from a -1, to a -2 to see if that makes a difference. Not sure if I want to order a GPS module...
Type: Posts; User: 89-289FS
Yes, everything works as it should, other than the spotlock problem. I have adjusted the boat scale from a -1, to a -2 to see if that makes a difference. Not sure if I want to order a GPS module...
I have a 2020 36 volt ulterra, and the spotlock works sometimes for 1 minute . Other times a little longer. It keeps winding itself up always to the left(port). If I hit spotlock, and it turns to the...
Thanks for the responses.
Thanks to the help of a gentleman from a local glass company, I found out that the original came from Marine glass specialties, which when you go to their site, connects...
Thanks for the responses. Thanks to the help of a gentleman from a local glass company, found out that the original came from Marine glass specialties, which when you go to their site, connects with...
Did an act of DUMB, and shattered the port windshield on my 1989 stratos 289FS. Tried google, and left a couple of messages at a couple of sites. Most boat salvage yards are for BIG BOATS.
Found out...
Did an act of DUMB, and shattered the port windshield on my 1989 stratos 289FS. Tried google, and left a couple of messages at a couple of sites. Most boat salvage yards are for BIG BOATS.
Found...
You have to install a through the hull transducer and Y cable. Had the same problem with my 800 series, and my helix gen 3. You can ask on the humminbird forum; but I think you'll get the same...
Is the trolling motor battery icon on my ulterra handheld a voltage icon, or a state of charge icon?
I installed a new ulterra on my boat this year, and it was a lot wider than the motor guide I took off. It covered the hole for my bow light. So I had to install something new for a bow light. I went...
I asked the same question for my 89 289FS on bass boat restoration. rojoquio, a very knowledgeable person on the subject confirmed what I suspected.You need a 1" hole for the flowrite remote...
rojoguio. Thanks for all the information. You saved me time and effort in trying to figure it all out. I kinda figured it was as you stated, that the hole, and brass sleeve OD were both 1". Looks...
Thank You both for your reply. mxmike. If I attempted to ream out the brass insert, by the time I reached 1" diameter needed, I think I will be through the brass insert wall thickness. But I am...
I would like to put a flow rite remote drain plug on my Stratos 289FS. In looking at the directions, it states the diameter of the hole the remote drain mechanism must be a 1" diameter. The existing...
Thanks Wayne. That's what I'm lookin for.
Steve
Ran the lithiums for my ulterra lower than I should. Everything turned out OK; but I don't want it to happen again.
Found a highly rated monitor, And it's only $40.00. An ancel BM300.Did everything...
Don,
Thanks for the heads up.What do they call it on amazon?
Steve
Thanks for the input. Looked at both options. Think I'm going with the Kootek. I also like the lure wrap idea.
Steve
My cover fit well with the motorguide that was on my boat. I made A 1 1/2" PVC frame that fits over my front and rear seat posts.
It has a center support that goes to the floor. I now use elbows on...
I installed a new ulterra on my boat, and with the power wire, transducer wire, and , foot pedal wire, I've got a bunch of ugly black wire on the bow of my boat. So I'm looking for suggestions,...
Here's an update. Took the boat out today. After 5 minutes or so. both my graphs went dead, Went to check the voltage on my electronics, and heading sensor battery, and found that the positive wire...
Thanks Bob. I haven't (until now)downloaded the manual. I went by the install paperwork that came with the motor. I'll add up all the numbers and take care of it tomorrow.
But I don't understand...
Thank You for replying to me. Both of my graphs, and the heading sensor are on their own lithium battery. When I checked the voltage when I got home yesterday the voltage on the lithium battery was...
Installed my new 112 ulterra Ipilot,w/MDI. Installed the heading sensor( no magnetic problems) . Did the Bluetooth pairing. Took the boat out and did the heading sensor setup( 2 circles).
Did the...
I got a new one for my 289FS from Garzon.
I have a 1989 stratos 289FS(19.5 ft), and I got my cover from Empire boat covers. It's been a couple of years since I got it, and I think it was $180.00. It's the 5 year warranty model. It fits very...