Then hook the yellow wire to whatever hot wire off the acc switch. Whoever wired 2 batteries without common grounds is fired.
Type: Posts; User: Basshopper
Then hook the yellow wire to whatever hot wire off the acc switch. Whoever wired 2 batteries without common grounds is fired.
Lowrance bought in store policy. If you bought and have issue within 30 days you can take back entire unit and exchange for a new one if over 30 days call Lowrance.
None of those HDS will do AT. HDS Carbon is the first unit that will do AT then HDS Live and HDS Carbon, ALso Elite FS also. The Enhance is back when mapping was not great. The New Cmaps and the way...
Straight Vertical lines is always electrical noise. Not necessary transducer cross talk. Could be how its wired for power and ground you could be getting noise through other cables in the bundle....
The rule of thumb for frequency, The higher the freq the more detail and the less punch power for range, The lower Freq less detail but more punch power for range. You will find that 20 ft and under...
You don't have to update But the next update that comes out will have it in anyway. So why wait.
The Us Enhanced maps from the Lives first versions of map were pretty low level. If you can find a Lowrance Pro Staff in your area then they can update your map with the contours plus. Then you will...
Would help to know what transducer you are using?
The S3100 has 2 channel sonar ports you can plug the HDI into the blue connector which is a 9 pin connector and Lowrance makes an adaptor for 7 pin transducers to 9 pin connections. you say it 5 pins...
I would call Lowrance and see what they say. You can't just buy a transducer for the nosecone you have to get the entire nosecone At least I have not seen one with a part #. I would push them to...
Go to Installation and make sure the transducer type has the AI3-1 selected if unknown select the AI3-1 and you will be running. Make sure Channel 2 is turned on.
this is why brackets vs into the hull are superior than punching into the boat below the water line.
To the OP if you think its the update download a new copy onto a 32gb card that has been formatted Fat 32 first and reinstall
How did you test on the water or on the trailer? you cannot see SS out of the water if that is the case. Was it 23.3 software? Did you update the AT box also
h
If you are trying to run Dual AT2 for Scout Wide it can only be done on HDS Pro. THe pro has software in that allow you to pair 2 scouts into one screen which give you a huge wide range and distance...
There is no issues other than 1 offs that is other issues other than 23.3 update. I have duals AT 2 and Pro and Live zero issues. At this point do it if you have an issue call Lowrance they are very...
russel marine
Most guys use the pointer on the AT screen if you have a point 1 on your boat then the pointer is dead on especially if you hunt from your console and watch your AT from there. Everyone uses this...
Yes you can
Did you go to the CMap website and update it? is this the PRecision Maps? if not what CMap do you have?
Good plan Then you will know if its something in your units or the transducer itself.
Put your card in another buddies Lowrance to determine if its unit or card that is the issue. My bet is the card. By chance was the card in any of your units when you did the updates? If yes then I...
You have to use some image software to reduce the resolution. so it fits and then no issue. The max size of a Jpeg is 12.40 MBs
You have to use some image software to reduce the resolution. so it fits and then no issue. The max size of a Jpeg is 12.40 MBs