Under Edit Data Boxes and Edit Navigation Boxes the only temp selections I have is Temp (WATER) and TEMP. Changed both Edit Data Boxes and Edit Navigation Boxes to TEMP and it works. Selection...
Type: Posts; User: ko4nrbs
Under Edit Data Boxes and Edit Navigation Boxes the only temp selections I have is Temp (WATER) and TEMP. Changed both Edit Data Boxes and Edit Navigation Boxes to TEMP and it works. Selection...
Yes, I selected Water Temperature.
Thanks,
Bill
Yes. Latest and greatest.
Bill
I double checked it and I have the temperature on a 2D view that appears correct. Temperature in the Accessories Test is Connected.
Bill
Transducer is connected. I set the box #4 under Edit Data Boxes and Edit navigation boxes both to Water Temp. It did show 32 degF in my garage when I first turned it on then it went back to the 3...
I use a XM-9-HW-MDI-T transducer with my Helix 10 and can't get a temp readout in the Data Boxes. I set box #4 to readout Water temperature but all I see is 3 little rectangular boxes. What am I...
I installed my AS GPS HS on my Helix 10 today and wanted to double check the set up. The manual supplied with the ASA GPS HS must be an older version because the instructions didin't match up with...
My update took a bit before it started. Give it more time.
Bill
Thanks guys. I'll get a screen shot next time out. I also expected a log to show a bright hard return with an accompanying shadow with maybe some limbs showing.
Bill
Are these ditches or logs laying on the bottom? It's in the Tennessee river.
464739
Bill
Thank you!!
Bill
I have the XM-9-HW-MDI-T transducer with my Helix 10 and also use Mega 360. I've read the manual but still don't fully understand the relationship between the standard frequencies and Chirp. If...
I would rather just set the frequencies back instead of all my settings. I went through the complete manual but didn’t see the default frequencies listed. Where can I find them?
Thank you,
Bill
Does the Reset set all the Chirp frequencies back to default?
Bill
I have a Helix 10 G4N. What is the general rule for setting the frequency range for 2d, DI, and SI?
I have the range set to maximum now.
Bill
Out on the water today.
After switching to 455khz. The brighter return is when I switched to 455khz.
452623
Mega Chirp before switching to 455khz
452624
Looks like it does switch back...
I haven't been out on the water enough yet to see. Going back out tomorrow and will pay close attention.
Bill
So if switching between Mega Chirp and 455khz eliminates interference with Mega 360 how can we be sure the graph did indeed switch back to Mega Chirp after switching to 455khz? This came up when a...
I hope that is not the case.
Bill
I installed one of these DC motor controllers to power my Minn Kota Edge 70 ft.lb. trolling motor in 2019. Was using a Hummingbird 798 with the TM-HDsi transducer mounted on the trolling motor. ...
The Midsouth Version 3 map I used in Oklahoma worked well in my non HD 798 when I selected the Oologah Lake HD map. Can I expect the same with the Southeast card if I used an older version my 798...
What map for the Southeast States (Al, FL, etc.) can I use in my older Hummingbird 798CI SI non HD model graph? I have the new mapping card for my Helix but need one for the 798 on the console for...
That didn't work for me.
Bill
Forgot to mention I set it back to Mega Chirp after disconnecting the DC motor controller.
I will post my findings.
In my case the interference was gone when I changed the Mega 360 frequency to 455 kHz. The DI+ frequency changes made no difference. Selecting only the Mega 360...