Where did u get this console?
Type: Posts; User: Jbunkley
Where did u get this console?
So I went and ran it this afternoon and all is good now. Thank Goodness!! It was the transducer this entire time causing my alarm to go off. Just letting everyone know.
It will be at around 15 then drop to around 8 then beeeeepppp..
Just purchased a used Tr18 with a 150 mariner magnum efi. It had a over heat alarm since I got it last week when you get above 5k rpm and Trim it out. So I replaced water pump, T stats and the poppet...
Lol
So I just recently bought a Triton Tr18 that came with a 70lb 24v Minn kota edge. I replaced it with a 112 36v Fortrex. I have a 16ft aluminum stick steer boat as well that has a 70lb 24v Motorguide...
I thought they kind of looked like flow-rite. Well the one in the 1st pic does but the other is very small.
Anybody know what brand livewell control valves Triton used back in 1998? I can't find any info on these in my boat.
OK thanks
Well crap!!! I think the switch might be bad. Finally got everything hooked back up and it's only putting out like 10v. All the other switches are putting out like 12.4v. So guess I'll be ordering a...
Found the diode I believe but really don't know where it goes. I'm a carpenter not a electrician lol. I do know a little electrical in houses but this stuff right here is above my pay grade. I wish I...
Hey man can u shoot me a message on ur panel cost? I have a 1998 Tr18 thank u
Man I really appreciate this. I'll check it out tomorrow
Thanks again
OK Thank you. Will see if I can find it on their website. I've called myself looking everywhere for a wireing schematic
Pic
OK thank u. This is the switch the one with red arrow. The switch above is main power
Sorry if this has been asked before but I just bought a 1998 Tr18 and the previous owner ran new power wires from the navigation and anchor lights up to the Roto switch panel but did not hook up. He...
Did you ever figure out the problem? I'm having same issue
I just recently inquired a 1998 Sprint 296 pro with a 200 mariner 2.5L..My question is and I'm sure it's been asked before but I can't seem to find it. Previous owner install a new tach and he said...
Just got the same rig..What setup do you have? Prop,motor height etc...Mine came with a 25 tempest and is very slow out of the hole
Ok thank you
Could someone tell me how to remove the center trim cylinder?I already have the whole bracket off the motor.