I have a 45 inch shaft 101lb thrust 36v fortrex available, works as it should just upgraded. 400 obo.
Type: Posts; User: usnbass
I have a 45 inch shaft 101lb thrust 36v fortrex available, works as it should just upgraded. 400 obo.
Replaced pack and everything working like it should. Thanks champ
Yes I checked top right piston at TDC with stop. Did the procedure marking the flywheel 2 times and splitting difference to adjust pointer. I did put the light on all plug wires and none were close...
Yes using a timing light after doing the sync procedure and marking flywheel. The marks are about 130 degrees from the pointer. It was on muffs while checking. I understand setting the idle in...
J225HPIFFN 1998
I am helping a buddy fix his motor. The original problem was it would not get on plane idled good but just didn’t have any guts. He rebuilt every carb and replaced coils. No...
1b466031
Motor starts right up and smoothe. When motor throttle is applied the motor reached 2500RPM roughly and will not increase. I have 1 code "STOP CKT ACTIVE". The code was cleared adn...
Also my assumption is the oil is not directed directly into the cylinder correct? Would it be smart to look at any check valves above cylinder 3 reeds( can they let too much oil in and it find its...
Forgot to mention I put new Boysen reeds in it and then a month later changed to TDR reeds. No difference. Are these the reeds you're talking about? Not sure of any others except reeds in...
0T164998
How do you determine which one goes to a particular cylinder. I have scoured the service manual several times and can not determine. Are the reeds sequential from top to bottom 1-6? I...
New water pump and telltale has steady stream in use. Thermostat replaced as well. Over heating telltale gets hot and steam starts coming from exhaust. Compression good and no signs of leaks...
I got the honor of meeting Neilslure and fishing with him last weeknd. Great guy and he can fish for sure. Thanks Neil👍
Interesting I didn’t know there was a check valve I will look it up and see what I find. Thanks joe
Any other ideas would be appreciated
Got my hands on a borescope and sleeves look good. I swapped coils and the problem stayed on cylinder 3. I also put a new harness on the whole motor last year. Could it be a ECM problem?
When plug fouls it is a black sooty buildup.
0T164998
I have fouled #3 plug on 3 straight outings. Was fouling last season but not as frequent. Can put new plug in and will run great for a little bit. Using timing light can see good steady...
Hey guys I will be in Cary from October 2nd to October 23rd for work. I have to drive my company car and can not bring the boat, but would like to do some fishing while there. If anyone in the area...
anyone?
0t164998. Just for some knowledge what are we looking for with fuel pressure and leakdown. I thought I had a previous issue fixed where #5 keeps fouling a plug. New wires, plugs, coils, wiring...
The 55 gallon drum is the best price per gallon you can get. Buy the drum and use it and sell gallons to all your buddies.
I like to change them every spring but want to let the double oil run out before I do.
Yes Savage it does, but I clicked the wrong one
So i goofed up and reset computer to break in after doing reeds instead of oil prime. Want to change plugs once break in is finished. Change them after 120 minute timer is done or wait for 10...
Have you used a DVM to check for power after the breaker? Check all battery connections to make sure they are clean and tight?
I use the VT-2 vents and please release me and have not lost a fish since starting. Even the Great lake smallies that are notorious for dieing have been released healthy and happy.