After a week of emailing back and forth with Humminbird CS, he said mega live transducer must be bad. While taking off the transducer, I found a cut place in the power wire. 😖 I called him back to...
Type: Posts; User: llstow
After a week of emailing back and forth with Humminbird CS, he said mega live transducer must be bad. While taking off the transducer, I found a cut place in the power wire. 😖 I called him back to...
Wayne - So the issue with some transducers is interference with the mega live when using the trolling motor? Would that interference cause the mega live to freeze up, or just be a lot of interference...
My Mega Live is giving me issues.
My electronics setup is…
Solix 10 G1 at bow
Solix 10 G2 at bow
999 at helm
Ethernet switch - all units are connected, but the 999 has very limited use through...
I need some help on setting up my boat from a tired old Black Max 200 to a Pro XS 250.
I have a TH Marine hyd lift, but suggestions on a good starting point when installing the engine so I can get...
I still have my original gauges that I replaced.
What gauge are you needing?
Thanks for the reply back. I didn't think that I would have to pay the extra amount. I will call this week.
Thanks again.......
I installed three of the HO UV light kits in my rub rail. Not too long after install, three leds on two of the strips quit working. They were right at the end of the strip opposite of the wire end. I...
Thanks guys. Now I have some ammo when I talk to the guy.
Where is that measured from, the top of the concave area or the lowest two points on the hull?
Hey guys, I need a little help dealing with a prop guy that has screwed up my prop.
I have a 1995 209 with a 200HP Merc XRi engine. 8.5” of motor setback.
I had a 25P Renegade prop on my boat...
On/Off pulse time is only for an AC circuit. DC dimmers control the voltage to the LED.
Look'in good limit.......
Fantastic job. That boat was one of the best looking boats at the classic. The blue/green combo was a great idea.
Looks great Calvin!! Good job.
OK, I will take some pix and post them as soon as I can.
My boat is serial number SOEU508HE495 Can anyone tell me what model and year my boat is? When I purchased it, I got such a good deal that I didn't worry about the exact year or model, but would like...
I took the Gambler out this past weekend. Everyone was correct with me having the trailer backed too far in. It loaded right up with just the top of the rear tire under water. Thanks for the help.
Awsome!! Thanks guys :thumb up2:
I'm sure that must be it. When I took the boat to test it before I purchased it, we had no issues loading it at the same ramp. I had had to do quite a bit of work on the boat, so I have only loaded...
Also, I made a typo. I have a 209dc not a 206
herk91 - did you purchase a different support? If so, what kind did you purchase?
Bob - I havn't tried not backing in very far to load it. I'll try that before I get into modifications. I was...
I have a 206 with a totally original Ameritrail trailer. The ramp is not steep at the lake. (Problem was actually worse on a steeper ramp) When I try to get the boat back onto the trailer, the bow is...
Thanks for the information on the transducer. I will check on the Transom Saver bracket.
I'm still doing some work on the boat before I put up some pix. The guy that had it before me nickled and...
Just purchased a 95 209dc with a Merc 225 EFI on it. First boat I've ever owned that will ROCK!!!
Where is the best location to mount a side imaging transducer on the transom? I would like for it to...