I read somewhere that you could reset the “bottom” limit of the trim by unplugging the trim sensor, trimming it up slightly from its actual bottom, and then plugging the sensor back in, and that this...
Type: Posts; User: clay-wallace
I read somewhere that you could reset the “bottom” limit of the trim by unplugging the trim sensor, trimming it up slightly from its actual bottom, and then plugging the sensor back in, and that this...
Everything seems right. All components were checked for tightness a few days ago because we thought maybe there was an issue with the (manual) Jack plate.
Can you offer any assistance/input on how...
2016 150 Fourstroke, serial number 2b174279. Engine doesn’t seem to trim as high when running as it has previously, and has lost about 500 rpm’s. My question is this, what exactly limits the trim...
It’s my dads boat, and his load is very light. Mainly just a a couple crappie poles and the normal batteries.
2016 Tracker 195 TXW with Mercury Fourstroke 150, serial number 2B174279. Tempest Plus 24.
My dad Purchased the boat a few months back and it runs fine but with low WOT rpm’s and speed. After some...
2016 Tracker 195 TXW with Mercury Fourstroke 150, serial number 2B174279. Tempest Plus 24.
My dad Purchased the boat a few months back and it runs fine but with low WOT rpm’s and speed. After some...
ttt
Bump
524809524808
$100 tyd
Brand new, never opened, Lakemaster VX Southeast mapping card. This is the new card that has color shading for all different depths. $110 shipped tyd.
Well I did all of the above suggestions, with no change. The ducer looks brand new. The whole operation prolly hasn’t seen the water a dozen times since that unit was installed. Any way to test the...
My dad recently purchased a used boat, and it has a single Elite 9TI with the totalscan transducer. It wasn’t showing a water temp reading so I went into the data sources and clicked “Sonar” and...
2022 225 ProXs 4stroke. Took the cowl off today and sat the cow on the back deck. When I went to reinstall the cowl this trim piece was laying on the deck. I can’t figure out where it goes. Can...
My thoughts exactly lol. I was just looking for a quick answer, not to bash Phoenix or my dealer.
The dealer didn’t put the gauges in.
Turns out you are correct. I checked behind the switches and didn’t find anything so I tore the console apart. Turns out they forgot to hook up all three harnesses at the factory when they put her...
Ok thanks. I’ll do that now and see what I see.
Yes it is
Brand New 921 Elite with 250 ProXS picked up yesterday. Took it to the lake this morning to start the break in and I have no power to my gauges. Everything else has power, graphs, pumps, 12v plug,...
I saw a picture of a boat with a set of blades, and they had an orange pinstripe running down them. Looked really sharp. Anyone know where you can order these decals??
Well after getting my boats level while on the water and checking that against my transducer I found that the "up and down" level was still very close to correct but after getting a good look, the...
It seemed to be pretty clean, I went ahead and cleaned on it anyways. I wonder if it getting slightly off level might cause this issue. Gonna carry my level with me tomorrow and get a on water base...
HDS 12 Gen3 and LSS2 transducer. Been using this same setup for a couple of years now, with no hardware changes at all, and never had a problem until now. The Right side of the side imaging has a lot...
I doubt you have the same issue I had but Ill share it anyway. Recently my 2010 250 ProXs blew, and my local dealer put a new factory powerhead on it for me. It ran perfectly through break in, and...
