I bought a 95 mercury 200hp xri 5 years ago now. Granted it’s not high on my priority list right now but I believe I was sold a bill of goods. Had it in the water a total of 3 times in that five...
Type: Posts; User: Mmtbpz
I bought a 95 mercury 200hp xri 5 years ago now. Granted it’s not high on my priority list right now but I believe I was sold a bill of goods. Had it in the water a total of 3 times in that five...
So essentially running on a premixed solution ..I would need to disable the oil injection system ?..okay..so similar to never running a snowmobile without its clutches for an over rev...
Your suggesting I mix 50:1 and run from a Jerry can for now ? Just needing clarification on your last post..what do you mean by close to powerhead damage ?? Can you expand on this..I am an hour and a...
Thx for the timely and all previous responses..
I have replaced all fuel filters recently as a method of diagnosis..I am not near any water so the only way I can test for poor acceleration is...
So .I have an update..I used a vacuum guage to test the map sensor spigot and thought I had vacuum..so I extended the hose to the map and sucked manually and the motor dropped it's idle..here's where...
Wot at idle would result in an over fuel situation correct? Along the lines of my thinking although I'm on the path of injectors not atomizing and squirting instead..
Thx for the info
I need to...
I cannot find a ser# anywhere on the transom and the powerhead has been replaced with a reman..no number on the frost plug..best I can make out is a 94 stamped in the block behind the starter
All of that was correct except that the fuel pressure does hold..
My thinking is the injector is not atomizing and squirting fuel instead..dirty maybe ?
Bit of a headbanger !!
I have checked all 6 cyls with a timing light..all of them light up the light..as I'm pulling off the plug wires I can hear the spark jumping the gap between the plug and wire..I have also pulled all...
Yes..all repaired..still runs poorly...
Not near water so diagnosing with muffs on.. someone told me that was a no-no..with lower end in a 45 gallon drum..idle is poor..stalls frequently..lots of...
Is it safe to run seafoam through these motors ?
Is it worthwhile as sometimes it just won't clean anything up ?
Peter
Hey guys,new to boats and this forum..bought a new to me bass boat with a 94 ish 200 HP Merc xri..have been searching for a ser# fora2 years..i apparently have reman powerhead with no numbers stamped...