Search:

If you have lights on your module then check continuity on the Ethernet cable from your unit to the module, should have continuity on all five pins

Thanks I'll give that a try this evening when I get home

I do see the option for flipping left and right but don't see an option for down? Any ideas?

I do see the menu option for flip left right...but no down..?

Can someone please tell me how to get my down imaging going, I can go to structure scan page and get side imaging good but when I go to menu while in side scan I don't see a selection for down scan?...

Thanks guys appreciate the input

What are your thoughts on using on board chargers? I hear some say they leave theirs plug up and hear others say it damaged their batteries...

I bought some more lugs from tractor supply and new lug nuts new bearing buddy , got everything back in order. I'll make sure to retighten ...thank you guys for the input

225 mariner

so I'm just missing the lanyard then...

Texas just passed a law that goes in to effect Sept 9th I believe that requires a kill switch with lanyard. Mine has a toggle switch. Would like to hear what some of you guys did to update yours....

Less than 500 miles new hub, you know I did notice that the new hub s lug bolts were a little shorter than the old one but didn't think nothing of it since the lug nuts got tight.

I was on the way home, you know I never thought about that but it's a good possibility considering that area!

Well they were not loose I can say because I put them on there with a 4 way lug wrench. The whole while thinking surely can't get them to tight....but now am thinking you can!

As in to tight ?

Anyone ever seen this happen before? New hub the bearings are still good and tight, there was no warning at first vibration I pulled over to see that four of the five studs sheared off...I've never...

Turns out I had a bad Ethernet cable and also the scan module was bad. Thanks to FXFishing I'm back going again. Thanks also to the ones that jumped in to help.

I did try the auto configure to no avail..if I remove the Ethernet cable from the box to my head unit I don't get sonar. But my transducer connects direct to the box and then Ethernet cable from box...

Yes sir the switch is turned on...

I'm only getting power to one of the pins in the power plug to the module...does anyone know if there is supposed to be two?

The yellow wire I traced back it's hooked to a constant hot then to a toggle switch then on to the module..

Thank you, I did check for the lights on the module and in fact am not seeing any lights but am getting power at the plug end. I'm stumped! Because since my transducer goes thru there first shouldn't...

Thank you Mr Bill. I'm gonna take a closer look for the lights now that I know where to look. Please one more question , should all 5 pins on the Ethernet cable have continuity when I ohm it?

I did check and am getting power to the module

Should all five pins of the Ethernet cable have continuity? Also I didn't notice that my structure scan box has any lights on it