I would not go with either one, though I like my ultrex, and generally speaking I don't like anything Power poles makes except the MOVE, because of its very; light weight. I would bite the bullet and...
Type: Posts; User: lpugh
I would not go with either one, though I like my ultrex, and generally speaking I don't like anything Power poles makes except the MOVE, because of its very; light weight. I would bite the bullet and...
Put a Blues Seas 285 series Switch/breaker of the correct amp rating (60 amp for 8-gauge, 40 amp for 10-gauge max) for proper ckt protection on the battery for the power supply to the console,...
Rick, please do not take offense to this, because we don't know what we don't know, think about it. If you do not have the knowledge or skill set to determine which way the seals need to be...
87 octane onley.
Start over from scratch and follow this for a guide line, 8 gauge is over kill unless you have 4 16 in units.
548853
You will need 10 to 15 Hp to achieve a 1 MPH increase in speed, It take a lot of mods to pick up 50 HP. A four bolt tunep-up is the best bet. Optimax 3.0 and do not modify it.
Set up is first and...
Need to go into network settings on the HdS, data sources and select the tank source from the list
twist lock
Reuseable filters are of similar mesh to the screen in the pickup tube, if it flows thru one of them as I described above, it will not coat the screens,
Store you funnels upside down with a cap on...
Automotive is totaly different and quite forgiving in this nature.
Optimax oil injection is very critical to be kept clean of any forgien matter,
keep rags and paper towels well away from the oils system, does not take many fibers or microfibers to actually cause this problem on the screens, cannot always be seen without a magnifier! Holding...
Rollor is new, This is considerably more than what is normal for these motors, I do know what you are refering to.
I dont know or trust the work done by the previous tech, thinking reed inspection will be next.
The 0 fuel I would some . concern with as should hold 15 plus for a while with no air pressure. Be sure the gauges and connections have No Leakage
smartcraft or vesselview link or mobilee is the quick easy way
1B492184 250 pro xs
Idle to 1000 rpm is perfect at 1500 rpm back normal all the up to top speed at 5850 rpm. 1100 to 1400 very rough, feels like random misfires.
Does not do this in neutral.
Owner...
548336
I do no not like the choice's mercury provides so I designed my own shown above,
Try applying Stabilent 22 to the pins on the MFD for the power connector, this will assure there is no voltage drop at the connector.
Amazon.com: Stabilant 22, 5ml Kit Makes 30ml of 22A : Industrial...
Did the reeds have any metal missing that could now be in the rails or direct injector?
Might be wise to send the rail to Don for inspection and cleaning.
are the bilge tank pick up tubes available, 2.5 gallon I think a common size?
93 psi, head up but, air pressure should not be bypassing thru the regulator, listen for leaks around the di injectors, fuel pressure regulator vent hole. air lines
pull the spark plug and check...
use a pressure regulator, set to 93 psi to test with
use a pressure relater set to 93 psi to test with
page 39 has all the info you need about breaker and wire size, every manufacture provides this
Mitch I highly recomend staying away from those cheap breakers, very unreliable, may not break when needed and most have a short life span, stick with Blue seas or Bussman.