I meant Garmin Force Kraken ... Auto correct changed Kraken to leaked...
Type: Posts; User: shuclan
I meant Garmin Force Kraken ... Auto correct changed Kraken to leaked...
I have a Bluetooth capable ulterra that I just took off of my boat. It's a 24volt, 80 pound thrust, I-pilot link, 60 inch shaft, US2 transducer. I did have an MDI transducer attached as well, and I...
Thanks for the quick reply, Wayne. Of course, my biggest issue will be that the Mega SI+ transducer on the transom will be useless without the Helix 9 Mega SI+ at the console. I think I'll have to...
Wayne,
My apologies if this has been asked. I have a Humminbird Helix 9 Mega SI+ G3N at my console, a Humminbird Helix 9 Chirp GPS G3N at the bow, and now I'm adding Mega 360 as well. If I were to...
I completely agree with you IceNitro. I tried to do the Onix update to version 3.110 and it just doesn't work. The instructions on the "new" website describe how to do an update with a zip file,...
Guys,
Hope someone can help me. I have an Onix 8SI and 10SI networked and linked to an I-Pilot Link (Minnkota Ulterra 80) utilizing the Bluetooth enabled remote. I have Onix version 3.030...
Wayne,
I am continuing to have sonar depth reading issues on my Onix bow unit. When I start up the bow Onix, the depth reads correctly for about 20 or 30 minutes, and then the sonar depth changes...
Wayne,
I think I would need the XTM 14 20 T for the ONIX, unless I got an adapter that would support the ONIX's round plug-in. The problem with using a trolling motor transducer is trying to figure...
Wayne,
I am looking for some info and/or recommendations on the following: I have an Onix 8 CI/SI at the console with SI transducer and standard HB 2D transducer linked with a Y cable and an ONIX...
There was a software upgrade for the remote and controller that I had to install that fixed the problem. All is good now. Went fishing yesterday and everything worked well. Now I just need to get...
Great advice, and I wish I had seen it before shipping my Terrova to a person I sold it to from the swap/sell section. I had purchased an Ulterra, and so I used the same box to ship the Terrova,...
I got the Ethernet hub connected to both ONIX units and the Ulterra. I configured the new network and everything showed up with the right versions except the remote, which said version 000.1 instead...
Thanks for the help, Wayne and Jimmy. Much appreciated. I am networking both Onix units and my Ulterra through an Ethernet hub, so I am sure I will have a bunch of networking questions as I get...
Thanks for the help, Jimmy. I did try a different slot, and it worked. That is interesting that it worked that way, but I won't complain. One question I have though, is whether the CHIRP...
Thanks for responding and appreciate the help. I used the same SD card with the 3.0 and 3.03 files that I used to update my Onix 8 to 3.03. I assume the software for the Onix 8 and Onix 10 is the...
I just bought 2 used Onix units, and registered both with My Humminbird. The software downloads that were shown as available on My Humminbird for each Onix was version 2.0 and version 3.00/3/03. ...