Search:

Ok I'm at the end of my rope ,I've installed the latest download to my unit also have installed ferrite rings on both helix 10's ran the ground wire from lower unit of tm to the neg wire on the start...

I've had my helix 10's for about a year and a half now , they have never seemed to work all that well. My latest issue is when I turn the si unit on all the writing is backward on the screen . I...

Well now its something new! I had the lower rebuilt about 3 weeks ago i took it out 5 times and now the lower unit is all messed up again grinding and very loud. I took it back and they said its bad...

Well found out it was the tach, Thanks for all the input .

my prop shaft is 5 inches below the pad !! man i have to raise it never measured it before.Hope its the tach and not the wrong gears!! does anyone know when the rev limiter kicks in on a 200 etech...

Heading down to have the tach checked, put a 27p tempest plus on still taching 6200 i have to check my prop to pad distance. not sure if other guys have this issue but if i lower my jackplate any...

I was thinking of that too, i took the boat out after work to run it after i lowered my 6 in jack plate all the way down , same thing 6400 and let off no rooster tail.I'm going to try a 27p. Not sure...

it says 26p on it

I forgot to put that down its a 26p flew out of the hole and seemed fine at top end until I looked at the tach it was at 6400 and i still had more to go, I did'nt have my gps unit on the boat it was...

I just purchased a new tempest plus for my 08 Stratos 294XL with an Etech 200HO because i messed up my Raker 2.I remember reading on here that this is the prop to use on this boat, I just took my...