Anyone change the 7 pin coiled wiring connector/harness from trailer to vehicle on their Skeeter trailer, the rubber covering the wires is crumbling and falling off. If so where did you find a...
Type: Posts; User: jerrym822
Anyone change the 7 pin coiled wiring connector/harness from trailer to vehicle on their Skeeter trailer, the rubber covering the wires is crumbling and falling off. If so where did you find a...
Talked to Minn Kota, recommended pulling one of the screws holding lower unit together, wet and full of crud definite water intrusion. The repair can now begin, thanks for all the suggestions.
Did you get it repaired yet? Having very similar issues with mine. Wondering if it’s working as expected after repair.
Passenger side rod locker door extremely hard to open, afraid the handle may break its so hard.Seems to be carpet is the cause. Anyone had this problem and have a solution to make it easier to open?...
I want to pick up 12 volts positive and negative from ignition switch wiring with key in run position, anyone know what color wires that would be?
Here you go CJC
You may want to look at the LG PK5 Bluetooth speaker, great sound for its size and fits nicely under the step. No need to mount it with its design it won’t move once put in place so easy removal to...
Anyone else seeing this problem, thrust washer keeps working up the prop shaft until prop is contacting Bearing carrier lock ring, this happened with the Yamaha 2 piece thrust washer which was locked...
Thanks for the part info, received and installed it today.
Under the head of the trolling motor there is what I think is a rubber plug of some type missing, not sure if something should be there or not. There is are 2 openings and the smaller one has a plug...
Thanks, that’s what I thought after looking around just wanted confirmation. I like to keep an eye on it you never know when there may be a leak you can’t see.
New to Skeeter Boats, have a 2019 Skeeter ZX 225 with Seastar tilt helm, there is no place to check hydraulic steering fluid on the helm that I can see as previous boat had so where do you monitor...
Need to replace drum brakes on 1998 Customline Tandem axle trailer with brakes on rear axle, anyone have the specs to order replacement drum assemblies, I think they are 10” but need confirmation....
Check your kill switch, if it is not fully in the run position the horn will not sound when turning the ignition key on. I learned this the hard way.
Great result, rotated the selector switch as instructed and tach now reading in line with the Smartcraft tach!
Interested to see what response you get, I have a 2006 225 Pro XS doing the same thing, Smartcraft guage reading normal but my analog tach reading approx 600 high, just started doing this last 5-6...
I got 6 years each out of the last 2 sets, just replaced them again with AC Delco Voyagers. IMO best batteries for the price.
Thanks Jeff, will do. Are the boat launches around the Pendelton bridge area still usable?
Good morning guys, Anyone been on T-Bend lately? Hows the bite. Going there next weekend but never been on the lake with the water level this low. Any suggestions or advice appreciated. Thanks.
Hi guys, My alarm horn quit working last trip out, does not give the 1 second beeeep when turning the key on. Bought new horn, tested & replaced, still not working. I can hear a very faint chirp when...