Search:

I use this, it's quick and easy !

https://www.gpsvisualizer.com/

Jack the front all the way down, then use 2 jack stands and a 2x4 under the rear at the step, raise the jack stands with the 2x4 on top of them about 4-5' apart as close to the step, then raise the...

Should be 14", 5 on 4 1/2. Also, your trailer vin # is on the Trailer Registration License card.

Plus............you can just take that wheel off and just run on 3 wheel to get you home, unless it's a long way. I've run 100 miles on 3 wheels with no problems.

Jack up the frame and put jack stands on it in front and in back of the wheels. Remove the tires, then use a floor jack to jack up each hub and then remove the "U" bolts from each axle. You may be...

Be sure to replace the inner and outer seals with new ones. NEVER re-use the seals.

I agree, it sounds like you're missing a ground. They are likely "Daisy Chained" and it sounds like you interrupted the chain. Re-connect the grounds and see if that solves your problem.

Depends on how heavy the line is. 6-8# is do a sweep with a little "Snap", 10-12# a little more "Pop", whereas with 12-15# I try to turn them "Inside Out" !!

The connections on the Blue Seas are Bat 1, Bat 2, and Output. So you'd connect the Pos to the Trolling Motor to the OUTPUT post.

What you want to consider most is, not the towing as much as the STOPPING power of the tow vehicle. Then also consider the lakes you fish most. How steep are the roads to get there and how steep is...

I'll take it. PM sent, send me your PayPal

Should be some part numbers on the one you have now. Google them. They are not used just for Ranger Boats.

Go to an Upholstery supply and get this. Spray both sides, let it get 'Sticky' then press it down.

PM sent

You charger has a set of leads that charges 36v and one that chargers 12v both off the same charger ??

I had/have one and was not impressed. It did ok thru sparse weeds and grass, but didn't work well in heavier weeds. I've heard some guys put 2 on and it works much better. i don't fish weeded...

New, gray, no red !!!

https://www.westernbass.com/forum/z520r-fold-down-pedestal-seats-t146657.html?sid=c50fb5e01d3060e22ed44cf7abc873b2

I went with the Fulton F-2 clamp on and used a mounting block with it. Best and easiest jack ever !!!

Be sure to use ALUMINUM Rivets too. If you ever have to replace one, they're easy to drill out.

This is the best stuff I've found. Been using it for years !! On Amazon !!

Remove the lid from the boat. Drill out the existing rivet heads and punch the remaining part into the lid. Drill the hinge and lid with a 1/4" drill and then install the hinge using 1/4" x 1/2"...

That depends on what you want to put back on. If you want a sleeve like is on there now, you have to disconnect ALL the wires and feed them thru the new sleeve. I cut the whole sleeve off, (using a...

Could be, check the fluid level, fill if necessary, and try again !

Top off the Master Cylinder and have someone pump the brake, like bleeding them, while you are under the trailer with a flashlight and look for the leak.

Well, I’ll be Damned !! Just got an email from them saying my shipment is on the way !!!