"Can". Not "Should". :wink:
Type: Posts; User: EuropeanAM
"Can". Not "Should". :wink:
This "3.5 amps" draw: If is consistent and still present 10 seconds after beginning your amperage test?
There will always be a short (momentary) draw that is significantly higher than the total...
Should not cause a problem. If you do have any difficulties, disconnect the VesselView Link, setup the MercMonitor, and then reinstall the VesselView Link.
VVL will often latch Station-2 just to...
If you would, please take a moment to review the Announcements at the top of the Forum, and be sure to provide the Required Info (serial number) when posting. Thanks! :beers:
Mercury does...
^^^^ This.
Check the fuse holder on the side of the engine. One of the low amperage fuses is blown, more than likely.
AnotherDistraction- you've gotten off the topic on this one.
IF the engine is rigged through a battery cutoff switch, Clean power directly to battery (which is REQUIRED), and the operator fails to...
There are just a few problems with this statement- but what I can tell you is that anything that alters the engine's emissions footprint in any form or fashion won't be "approved".
Additionally,...
10w30 Synthetic Blend is the correct oil for your engine.
If you would, please take a moment to review the Announcements at the top of the Forum, and be sure to provide the Required Info (serial number) when posting. Thanks! :beers:
"Rev Limiter" is...
Verbiage on that fault may not be quite correct, the precise fault info is critical as there are a number of different faults similar to this.
One easy thing to do is to make sure the throttle is...
It is often quite hard to get adequate cooling media fed to this engine. See the Sticky Posts and FAQ for suggestions about finding a trough or bin suitable to submerge the gearcase.
Travis- that depends on whether you intend to use an Analog Gauge (or NOT).
With ONLY Smartcraft: 8M0142696.
The other sensor (along with a tee, piece of hose, and adapter fitting) works with...
Additionally, if you have to change an SSR Hub Kit that's mentioned in this thread, the odds that you'll be reinstalling another hub kit and continuing your trip are NOT in your favor. That kit is...
You're welcome!
It is a separate device (entirely different from Vessel View Mobile).
That will not prevent "only trim" from functioning. If it weren't connected correctly you would have none of your pertinent engine data.
System Monitor can be installed with no junction box or...
This particular manual is quite detailed for most of the common services, and broken down into the various engine models currently in production. Enough so that I ordered several the moment I saw...
+2
Where is it mounted, on what engine/serial #?
Check plugs and wires. Wires should be resistance
tested- and of course a spark test.
I thought it might be one of those “don’t be like Bob” jokes.
Does it hold at whatever pressure you're getting? Separate, KNOWN ACCURATE gauge tried?
Drop Rhonda an email (see her post, pinned at the top of the Forum). Smartcraft Connect is what you'll want with your Garmins: Available as an ON-ENGINE, or AT HELM setup (location cannot change)....
Peel back the convolute and look at the wire colors.
One of them is likely blue w/black stripe. The other is likely black or black with an orange stripe.
These would be a Tank-2 circuit (from...