How often should this filter be replaced? Does the clear bowl need to be drained off occasionally?
Type: Posts; User: Jacobini
How often should this filter be replaced? Does the clear bowl need to be drained off occasionally?
Does someone know how to diagnose a trim indicator problem? My needle moves slightly but will not go down.
My 98 zx185 has red letters with a black halo. It must have been a bad year for stickers since mine a starting to come off.
I have a 1998 150Vmax and was told it would be in the neighborhood of $300 for a rebuild. Does this seem like a reasonable price?
Thanks! I'll experiment with this.
It's the filter under the cowling. I have a 98 Vmax 150 and need to find out which Racor fits this motor. I think the best way to mount the filter would be to screw it into the stern. Any...
I managed to remove the fuel filter assembly and found a brown/black grit and some larger debris. Any idea what it could be and if it would cause the motor to run like it's not getting enough gas?
...
1998 Yahmaha VMX 150
I managed to remove it and found a brown/black grit and some larger debris. Any idea what it could be and if it would cause the motor to run like it's not getting enough...
Thanks fellas!
Do you know the procedure for operating the livewell timer?
Also, I have a flasher in the dash and a sonar on the side. I cannot operate both at the same time. If I do the...
I am without a manual and have a couple questions.
Should the livewell remain empty when the indicator arrrow is pointing to empty? Water enters the compartment when it's in this position.
...
I'm considering installing a water separator but I'm not sure where it could be mounted. I was hoping to see some photos to get an idea for location and mounting bracket examples.
The fuel filter assembly that I have is mounted via a bolt on top. I'm not sure how to remove the housing in order to remove the fuel and possibly replace the filter. I've turned it both direction...
Tom- Did you say a new filter & separator remedied the problem? I wasn't sure if you may still be having trouble.
In addition to the stock screw mount filter? The filter has a threaded bolt on top, but I couldn't determine if the filter housing was threaded into the cap.
I'm open for any suggestions.
What is the best way to remove the fuel filter assembly?
I can see some sort of black foreign material inside. The only thing that I can think of is fuel...
I noticed in the fuel filter assembly that there is some type of black foreingn material in there. I intend on removing the filer housing and cleaning it out. I hope my it's not my fule line but I...
Jason http://www.bassboatcentral.com/smileys/eyes.gif ,
Does this policy cover Lower unit damage in the unfortunate event it is lost or badly damaged?
In regards to tackle, rods, misc. are...
I'll contact him today. Thanks!
I'm looking for advice on boat insurance. I would like to know which Agency provides coverage for personal effects (tackle, electronics), TM and lower unit repair.
I'm not sure about the...
Run it through.
I finally put the boat in the water over the weekend and have started the season on a bad note.
While under power the motor stared running rough and felt like it lost power, at idle it sounds...
NAPA can match them up. I would advise going to the next rating though because the set I ordered seemed to be light. Mine were $24
Steve, My axle has a zircon fitting on the end of the axle. Doesn't the lube enteirng through this fitting address the bearings?
Are the seals visible? When I removed all of this I didn't see...
Must the axle bearing be removed in order to access the brake shoes on a drum assembly?
Has anyone replied to you about this? I'm in the market myself.