Ok that makes sense. Thanks Don. I’m dragging to back two hours to have them look at it again.
Type: Posts; User: Xtremewelder
Ok that makes sense. Thanks Don. I’m dragging to back two hours to have them look at it again.
Don had the computer read and they replaced a sensor on the crank shaft and sent me on my way. Took the boat out in the ocean Saturday and the motor sounds great, fires right up but as soon as I push...
Ok thank you Don I’ll find a dealer.
I replaced it with brand new one with 1000 ca and 850 cca and it’s sending the same code. Maybe I need to clean the fuel injectors and try again. Is that something I can do Don or should I send them...
Now that I look at it , the battery is a cheap local make with a CCa of 625 only. It’s the same battery I’ve had since I got the boat 4 years ago. I’ll replace it and see what happens. I don’t know...
Model:1150f23hd
serial: 1b987050
So my boat was sitting for 6 weeks and finally got around to getting her started. It took about 20 minutes of cranking to get it fired up but ran fine for a few...
Thank you Don. I’m sure it’s the fuel that’s the issue. I will get intouch with you guys tomorrow and order the manual. I would like to do this myself for future knowledge. Thanks again.
I checked thanks for responding. I’ve narrowed to bad gas in the fuel system. How hard is to get the fuel pump? Has anyone done this before ?
thanks
I am in need of some help. I have a. 150 serial number 1B987050 with 700hours on it. Went fishing last week with no problems but yesterday the motor would not start. It cranks fine, I checked fuses...
Serial 1b987050 . I think my batteries are not being charged by my engine. A few weeks ago I went to launch only to find out both batteries were dead. I installed a dual battery charge to make sure...
That's all I use to trailer mine. I've never used a transom saver. I do a lot of highway traveling and never seem to have a problem. I have the same motor on my NorthRiver.
Don I watched a video on flushing your outboard in a trash can with a couple cups of simple green, is this a good idea? I have a terrible time getting my 150 to work with earmuffs so I've been using...
Don I bought the Mercmonitor from you guys and recently bought a Lowrance hds Gen 3. My question is besides the Nema hook up is there anything I need to do as far as set up on the Lowrance? I saw...
Ok thanks Don, I'm returning the elite and getting a HDS... Still having trim problems but I'll call on Monday.
If I added the separate gps the the nema will it pick up that signal?
Don I got back on the water today and changed the monitor to read the mph from the gps unit and I'm still off... I have the lowrance elite 7 and the the gps would read 3 mph while the Mercmonitor...
Ok thanks I'll give that a shot. Thanks for the help
I'm hooked up to my nema 2000 and I believe it's pulling the info from there. Maybe I have that wrong. I had a analog speedo that I removed to add the Mercmonitor and I capped off the pitot. That...
Don I used my boat this weekend for the first time since installing my monitor ( thanks for the help by the way) and I have a few questions. I'm assuming since the info comes right from the engine...
I agree, they have been a ton of help sending me the right Mercmonitor. Can't wait for Thursday!!!
I don't have any smart guages, the only guage that works is the tach. Is that my problem I'm not sure the setup the previous owner had but I would like everything to work. Thanks
first let me thank everyone for posting and answering the questions, its been a wealth of information and im glad i stumbled across this site.My engine 1B987050. I just bought the boat and the tilt...