Search:

I wish there was a way to put the selector on the screen like the gain or depth setting.

Put Livescope on my boat this past fall used a couple of times, but went to use it resently and when I switched orientation it would not sense automatically. Wondering if something is wrong? Would...

I will have a board tomorrow to swap out, what calibrations procedures do I need to do ?

Thanks for the help.

Who are your most reliable sources for parts ? And thanks for the help.

I did check these as you said and they were all in the right positions .

Still doing the same thing, Im guessing its the board, i-pilot still showing that its still showing with no movement with the red light flashing.

485524 I found this when hooking up to check voltage on the actuator , which did have 24v on it but I guess its not getting the amperage. Is that the relay for the actuator?

Ok, I will do step 3, but another question is , who does everyone use that is reliable and trusted to order their parts through ?

I have done a little trouble shooting , it will deploy but when trying to stow it will trim up to position but the actuator will not energize to stow it. The I-Pilot shows it to be stowing. I...

Well just checked my email for the shipping info, looks like they shipped me a new IPilot, not what I expected but im glad , I use it alot.

I have regular wet cell deep cycle , I bought it factory refurbished through Glens Reel and Rod. They have great service . The control board and the trim motor went out a month after so Minn Kota...

I checked voltage to the motor and it was correct but the meter on the remote shows maybe 20 percent charge.419245419246

After having the control board replaced a few months back the motor voltage has not read correctly even when batteries are fully charged. Has anyone had this happened to anyone else?

I have a X56 which is 18'3" with a 2000 Merc 125 on a 8" Atlas hydraulic JP . im turning a 24 Semi cleaver 4 blade and I have been getting 52 out of it regularly by myself but sufer a little with 2...

Ok I will thanks.

Ok , that will help on my quest of finding a prop easier.

So they sould both turn the same at WOT, just the Plus has the PVS?

Another question for you , im running a 2000 Mercury 125, would the Trophy be better to run than the Trophy Plus of the same pitch ?or it dosnt matter?

Thanks , I wasnt sure.

Mark , I have been looking for a 24P Trophy, but they are pretty elusive. If I get 25 P how much can be added or taken away if needed?

Well I was planning on getting back under it to paint, so I might go ahead and sand and spead a can of that to seal it.

TRO4 is a Power Tech copy of the Trophy is that right?

It is water resistant but not waterproof, so with the epoxy paint it will be considered waterproof.

Ol man river , I hope I didn't ask a bad question?