Search:

I’m going to try that this weekend.

After our club tournaments are over I’m going to add a 10” hydraulic jackplate and go from there. I’m gonna lower motor to 4 1/2” for now. I will work on set up again then when I have more time.

That’s what i thought. I’m running right at 5400 right now. On every fiberglass boat I have had raising the motor usually helped raise rpms until I lost water pressure. I raised motor and got less...

I’m not gettin any chinewalk now that i raised motor to 3.5 but it was just the porpoising. What is the hpdi motor supposed to run at for wot? I’ve read 5400 and 5900 to 6000.

Are you running hydraulic or manual plate? That kind of info is what I’m looking for. I have all 27 series blue top batteries and I don’t run a heavy load. Maybe 7 or 8 lbs of plastic and 10 trays of...

I have looked everywhere that I know of to try to find similar setups with the hpdi and a 23m prop but can’t find anything. I want to get a 10” hydraulic jackplate and have the prop worked. I’m...

The factory 6” zlock.

I can drive through most chinewalk but when the prop to pad was 5 3/8” and by myself it was like it was trying to swap ends. I tried and tried to get it under control but couldn’t. It still...

I just got a 2015 X19 with 175 hpdi. First trip out by myself chinewalk was so bad I couldn’t control it above 60. I could get 63mph and 5600 rpms. If I slowed down to stop chinewalk 58 to 60 it...