There is a setting you need to have set for shallow water, or your transducer is not level to how your boat sits in the water.
Type: Posts; User: AlumaPro
There is a setting you need to have set for shallow water, or your transducer is not level to how your boat sits in the water.
I have two leatherman's I have a Wingman which I keep in my boat, and I carry my signal on my hip in the sheath. Great customer service IMHO.
First Gen Ultrex 80Lb 24V
:roll:
Strangest drinking fountain I've ever seen......
If he has the ducer backwards and mounted it on the wrong side of the bracket than yea there is(on the braket)
the only movement I've ever noticed is the mount attached to the shaft, didn't have...
Sure there is, If he has the transducer mounted to the smooth side of the mounting bracket. In the the installation book it shows how the Ducer should me mounted.
DON’T DO THIS ^^^^^^^^^^^^^^^
I you have the rubber washer and the teeth notch lined up hand tight will hold it in place. It sounds like the transducer is on the wrong side of the mount.
I from...
Be more specific please... Now when you say moving, is the transducer it self physically moving? or is the desired selection on the graph changing? if its on the graph hit menu > position > select...
Make your own...!
As I was reading your post MCK that ground on the AT box The terminal on the top of the box is not current carrying and should not go back to any voltage source( Like the Negative Terminal on the...
I bought mine new in 2018 when I ordered my boat. Since ownership the only thing I've had to replace was a cable for the steering.
I saw this one, but curious if anyone has done it recently with the Carbon or Lives units
So after searching I'm curious if anyone here has not only installed one, but installed one on a Aluminum Rig yet? and performance if it works or not.
If this has already been answered please post...
Clear Finger nail polish
Good Morning :mug: :salute:
Park on a dry level surface, with the plug in fill the bilge area with water up to the floor. Sit back and look for a wet spot on the ground and trace it back from there.
On your bow unit select the 83/200hz universal transducer if it connected to the trolling motor using the 2d sonar.
Still won't keep it dry. the corners of the opening's are not sealed. Only way to truly fix it, is seal the corner seams and install a drain hose down to the bilge area. other than that the cooler is...
I have a question? StabbleView enable or disabled?
How Shallow of water are you in?
Is your trolling motor level with your boat? meaning is the shaft of the trolling motor perpendicular to the boat?
I found that in too shallow of water and...
That ground is a Earth/Chassis ground that you connect to the top of the box. If you have a Tin boat connect it to a solid spot in your boat with 10ga. foot long. This line should not be ran back to...
I have a Renegade 1875. Great boat built proof. Just none of the compartments are waterproof
I've read that the picture quality is better on the 9 over the 12 or 16
Don't do it!! the superglue will eat away the plastic, make it more brittle.