UI on the Garmins is definitely better making them far easier to use
Type: Posts; User: GJG
UI on the Garmins is definitely better making them far easier to use
Carbons are evidently a thing of the past. If you found a new one i’d think hard before buying it. Also if your going ghost I’d go with the live
Just wish lowrance had a process to call the customer before just sending it back.
Now decision time where to put the Live LOL. 6 mths ago i added a garmin ultra with livescope at the bow. Wish...
Update
Talked to Lowrance CS again....rep said send it back...i said send a replacement today with a rma for this one. Already spent overnite ups once and at this rate have no confidence in...
Tried a new transducer early in the process. Also same issue at console which is different ducer. My other unit works fine either location.
Talked to Rocky at lowrance customer service. Very nice and helpful Csr. He went over the process and stated if it checked out they would box it up and send back. I asked him to make a note to CALL...
Thought so. Thanks for the confirmation 👍
Definitely worth a try. Thanks for the suggestion 👍
Tried that....twice LOL. Will have to make time to sit in her and call lowrance i guess
Had the hot foot issue. Stop bolt backed out somehow and i had basically his same issue until i figured it out
Transducer entered correctly. Im at a loss
The lever operated plug likely. Mine wasn’t pulling all the way in and seating like it should
‘18 FX21.
Is the standard manual setback 10” or 12” ? I’m ordering an Atlus Hydraulic and my boat is at my lake house an hour away so I can’t measure it. Called my Skeeter dealer and parts guy...
Check the 12v ground at the motor.
What was the fix?
No luck. Hard reset both units. Front sonar is scrolling as if its working. Console is blank. Data source set to this device
How can i tell if the down side scan is being seen? Im only getting...
Updated both carbon 12s to 20.0.1 and I’ve lost sonar and water temp at the console and it appears downscan is gone also.
Sonar installation screen shows no temp sources. Checked transducer and...
email sent for pics
What size is it?
no, but i'll see if i can get some this week.
this.............
Rigid Industries 48208 A-Series
400 lumens
...
thanks!
i like the battery switch for the power poles.....i assume you are running both power poles off 1 battery? Are you using a 2 position on/off switch or a 4 position on/off/1/2. also...is that a...
another for peg board
http://im1.shutterfly.com/media/47a3ce07b3127ccef42057e9423a00000030O08CZMWLJw5ag9vPgg/cC/f%3D0/ls%3D00005982110220131026210719589.JPG/ps%3D50/r%3D0/rx%3D550/ry%3D400/
...