Yes and replied in PM
Type: Posts; User: Wayne Worthy
Yes and replied in PM
make an offer
45 inch with removable mounts and brace. only used one time. 36 volt 110 lbs thrust $600 plus freight. May help with freight? 417-224-4013 text or call
479736479734479737479739
Hydro Tec offers Plasma coating the whole block. Call Mat or Jon 417 725 5746
you can see rpm if you data log but most dealers don't know how to do this. We have done over 500 flashes in 10 years and never seen a problem!
Those part numbers are correct and the 32 bit is much better running characteristics
Did the heads get re-torqued after running for a few hours?
CB Marine is the bomb
352326
We have been flashing these engines for over 10 years! Need to prop 6000 to 6200 rpm
We have yet had one go "BOOM". We have been doing these for over ten years. Voiding the warranty is against the law but it could effect how the warranty is paid
Yes it will plug and play but it will not help as a matter of fact it will hurt your performance. The 225 and 250 or different as far as port timing
We been doing this for over 10 years and never seen an issue
Nothing is erased when the flash is installed the hours stay the same. No worries on the transom!
Not true. We have run over 300 hp on all the models that you have listed and more!!
Send ecu with return address and phone number and what tune you want. Also you will need the throttle cam replaced on that model.
DITTO
Hydro Tec has been offering ECU programming for over 10 years and are the Yamaha experts. We are available to answer your questions and help you with setup and props. We offer same day service if...
Chris, you should consider doing this for a living:roll:
:popcorn::smile:
can you provide a model number since there are several models that could be applicable
I am assuming that you have a 3.3L 200? If so you will need to upgrade the ecu to a higher hp to get any benefit out of a Phase kit. We can offer a reflash to your ecu and some other parts.
It keeps an old man from bending down! :smile:
http://www.bbcboards.net/attachment.php?attachmentid=295731&stc=1
the transom looks the same, I can't tell any difference in appearance
The SHO actually weighs the same as a Mercury XS 3.0 and a little lighter than the Yamaha HPDI. The Super Charger does weigh about 20 lbs