thank you for the responses, i appreciate the help
Type: Posts; User: flippingrass
thank you for the responses, i appreciate the help
good morning, thanks for any help i can get. i have a 2002 ez loader trailer. one of the white back up lights burned out and i need to replace it. the only number i can find on it are PM 421 2. ...
Thanks everyone. I installed it Friday and got to use it yesterday. Definitely one of the best things I have done to the boat. Thank you all for the help
Doyce, thank you for your response I appreciate it. Looking forward to installing it and using it.
If anyone has added a recessed tray to a TR20 (mines a 2002) I would like to know/see how far forward you mounted it. I know everyone says as far forward as possible but looking for a possible...
Thank you for taking time to respond, I appreciate it. Yes, it’s 6ga wire for the troll motor. I do have a blue seas bus bar with shut off switch in the boat. It definitely helped clean up the bulge...
i am in the process of replacing a 24v motorguide tour digital to a minn kota 112. currently in the boat are 2 breakers. one breaker has a positive jumper running to the battery and then a positive...
Rich at Hydrilla gear is another board sponsor. I have ordered from him several times.
https://hydrillagear.com/
thank you, appreciate the advice.
2001 Merc Optimax 225hp serial #0T383064
Today I ran to the dock to get something from my truck. Boat had been running great, no issues. After getting back from the truck, I let motor warm up...
I tried to place wood under skeg but it didn't help. I didn't do anything else before asking. I error on the side of caution and like to ask before I do something not advised. Thanks for the...
i have an 8" th marine z lock jackplate. i tried to raise the motor, 225 optimax and i goes up uneven. all six side bolts were loosened. the center adjustment bolt was hard to turn clockwise to...
talked to someone at easternmarine and they were very helpful. going to get a new actuator and flush system. thanks again for the help
thanks for the quick response, i appreciate it. i tried to and pull the actuator and it is hard to move by hand or traveling maybe 1/2" in and the it returns.
i have a question then. how...
I disconnected trailer wire harness and trailer won't back up, brakes lock right up.
Filled the reservoir up with new fluid and took the trailer for a ride. In frequently the tongue still slams...
I have a 2002 tr20 on a dual axle trailer. I believe it's an ez loader trailer. Had the bearings and brakes checked and all look good. But there's an issue with the brake cylinder I think. The...
2001 merc optimax 225
serial #0T383064
I want to drain old fuel through the fill neck as oppose to using fuel line. I was hoping to use a old primer bulb with 5/8" hose (same hose as runs under...
I have a motoguide tour digital 82lb. I need to adjust the tension on the steering cables. If i remember correctly when i go toe completely down there is enough slack that the cable "ball" can...
Sorry
http://i62.tinypic.com/v4cgtz.jpg
http://i58.tinypic.com/30kd8jn.jpg
the red lead going to the left is the one that is taped off at the end
I bought a 2002 triton tr20 almost one year ago. Ran the boat all summer on the batteries that were in there. Took the batteries out to winterize boat and honestly paid no attention to how they...
I posted this in the bass boat set up forum and got some good advice. Just thought i would post here to see if anyone else had insight.
I have a 2002 Triton TR20 that I am removing a 5.5" manual...
I have a 2002 Triton TR20 that I am removing a 5.5" manual jack plate and replacing it with a 8" manual jack plate. I plan to try and run a 25p tempest plus or a 26p tempest plus but also have a 4...
Thanks for the insight
I have a 2006 ford f150 xlt supercrew cab. Over the past year the chrome plating on the rims began peeling off. Recently one of the rims cracked on the inside of the flange and will no longer hold...