Search:

Looks like a live well timer board

Needs a caption "Insert sign here"

It sure does make for easy clean up. Nice looking ride

I just bought mine and was resealing everything back there when I loosened them water came out on both sides. No silicon on the outside that I could find

I'm in the process of drying my 190 out around the tie downs. Luckily there isn't any rot and the water was just around the tie downs. I drilled some 1/8" holes in 4 different places then put my...

Have you checked compression and spark yet?

I am always looking to upgrade and I came across a 1998 190 so I sold my 184. First order of business install the electronics and TM off the 184 on to the 190. Second order get rid of the RITE HITE...

4200

They are not fun to change. I would replace it and any pumps while you are in there if they haven't been replaced before. You have to pull the batteries and oil tank to remove the floor/cover. The...

My 90 184 still had the original seats and they were the fold down type.

I use mine as storage and have Brute ice chest that fits between the rod lockers. There is only about an inch difference from the deck to the ice chest and it's sturdy enough to hold my fat A$$ when...

Aqualon is what I bought last year.

I second Deans. They made the adjustments I needed when I ordered a cover for my 184 just by pictures. They will get my business again when I order a new cover for my 190

Nope. The one in the link you posted is mine. It's sitting in my garage in Arlington.

That year will have wood in it

The original owner had his motor put on a new hull in 1990. All the paint is still on all the head and block bolts so I have no reason to think it has ever been apart. I was looking to repower it...

My 184 is listed in the for sale section. I recently bought a 190 and the wife isn't happy there is a 184 in the garage and a 190 ion the driveway.

Mine is mounted to the jack plate

The water would pump into the bottom of the boat running out through the bilge pump unless you put a one way check valve in the hose between the "T" and the bilge pump. Keep in mind above the "T" it...

Sounds like it may be sealed well already. The 2 I have done came off pretty easy but they weren't sealed very well.

Make sure you stay closer to the back like Pat said. Most boast have a piece of wood glassed in or a thicker area about 8 to 12 inches forward from the drain plug to mount the bilge pump to.

I just bought a 3 step E ladder from R&R that uses the motor bolts. They also have different brackets to mount it to the jack plate.

Good Morning! The older I get the closer to home I fish

I did my 184 last year and there was no silicon under the cap at the top and the brass drain at the splash well was cracked. I resealed the jack plate and all through hull fittings. I just bought a...

Now I own 2 Champions. I was looking into repowering the 184 and found this boat so I bought it instead. There is nothing wrong with the 150 on it but was looking to upgrade to EFI. So now I own 2...