Bump
Type: Posts; User: willymac
Bump
Looking for a possible trade of fury 3 25p for the 25.5 bravo?
I'm not selling my 23, it is the prop I need. I have a 25 fury for sale or trade and I'm looking for a spare prop.
I have a fury 23 on it now. I still have my old fury 25 which is too big and someone wanted to trade a trophy plus 24 and I was looking to see if it would be the right pitch for a spare prop.
What pitch trophy plus would I need when swapping from a Fury 3 23p?
I will sell for $600 shipped.
Finally a real review on the question asked...I decided to order it anyways based on their reputation. It shows up tomorrow.
8/10 Fury 3 25p. Repaired and blueprinted by local prop shop, Propworx, had a slightly bent ear. Used for two years after repair with no issues. Repowered to 4 stroke and now too big. No hub...
From what I understand, dd26 is just rebranded tuffskinz. Only tuffskinz has an option for the oil access door flap secured with velcro. I've already ordered one so I guess I'll find out on a few...
If you don't clean your motor before you put a cover on, I could see where it might. But the one I had on my 2 stroke for 5 years have no scuffs or scratches.
That's what I figured.
I have this posted in the Merc 4 stroke forum, but I figured it would get more traffic here.
Who has any experience with this cover with the velcro oil door access flap option? I'm wanting to...
I'm looking to see if anyone has any experience with the velcro oil access panel option on the Tuffskinz vented motor cover. I'm looking to see if it affects the integrity or fitment at all, or if...
No I do understand the importance of it. I guess I'm just venting more than anything, especially since it has been confirmed that it is normal behavior of the system. I'll just have to deal with it.
I understand how I blew the fuse, question was, is that normal, and you answered my question that it is.
My concern is, I like to completely disconnect power on my boat while in tow and storage...
Key off, battery cutoff off, 14 pin at rear of engine disconnected, and clean power fuse removed - no solenoid click when pushing engine mounted trim switches, replaced fuse only from above, faint...
Sorry, I edited my post. The second test was with 14 pin at motor disconnected.
Key off, battery cutoff switch off - clean power fuse blew when trying to operate engine mounted trim.
Key off, battery cutoff switch off, 14 pin disconnected at back of motor- clean power fuse...
3B460301 250 ProXS
My clean power is connected directly to battery. My engine is connected through a cutoff switch. When switch is in off position, if the key is turned on or trim switch is...
I would stay at Fin and Feather. Good cabins, good restaurant on site, good part of lake. They have boat slips for rent and two launches, only one is wind protected. 40 minute drive to umphrey and...
Impact driver is for screws, impact wrench is what you want. 3/8 dewalt is what I use and can normally break the lug nuts loose.
I had a 2012 H18 with F115 and 6 inch manual plate. I ran a Yamaha K21 prop and was able to see 52-54mph regularly. I don't remember any other details on the setup.
I'm not exactly sure what the...
Try etsy.com
Next time you are in rough water and running hard, look back at your motor and see how much it moves.
Its not, but why wouldn't workers strive to make a living wage from a company that is very successful. The salaries of these employees being a little higher wouldn't put a strain on Amazon. The...