Search:

I run (2) AT2s with a 12” Live and a 12” PRO on the bow and a 12” PRO at the console. I power it all, and my accessories and outboard with a 190ah Millertech that I purchased from...

I installed my BFE True Arrow and it’s phenomenal. Prior to the install, if I moved the pedal a small amount the arrow wouldn’t move at all and was oftentimes lagging to one side or the other of...

Marc - I’ve been running a very similar setup with (2) AT2’s for about 5 months now. It’s awesome once you get it dialed in. I have both of my AT2 ducers mounted to a Rite Hite Turret vs. on the...

Thanks Marc!!!

PM sent

I reported this issue to Lowrance techs on February 14, 2023. I also ran AT1 for 2 years with no issues but my AT2 is freezing up about once an hour. It sounds like a software update is being...

2003

Texas fishing forum?

It will be compatible with HDS Live, HDS Carbon and Elite FS units.

I think it’s a shallow water anchor for the bow of the boat, since they’re saying “it never backs down”.

I’m not 100% what it is... I just noticed it on the lip of the motor and on my motor toter. It seemed to have a tacky / thick feel to it like oil and it was brownish / yellow in color.

I noticed my 2003 Yamaha VMax ox66 250 hp outboard is leaking oil / water from the seam where the lower unit meets the midsection and comes to a point. Is this an easy fix or am I looking at a major...

Get the correct transducer shield and saver with the adapter plate for the 10” Slidemaster and it’s super easy to mount.

Thanks for all the help. The fiberglass wire fish pole starting from the fuse panel opening did the trick.

Does anyone have any tips / tricks for snaking wires from the transom compartment to the console in a 2003 Champion 206? I've tried a metal wire snake and pulling old original transducer cables, but...

Thanks guys!

Prop Experts,

I'm Installing a Fury 25" 3 blade prop on a Yamaha Vmax 250 using flo torq 835271q2 hub kit and there's already a thrust washer on the prop shaft from my Yamaha prop. Should I just...

Joe,

That may be the issue! It was raised. Should I be able to go level it, remove the bottom screw, attach the pump, then remove the top screw and fill it the rest of the way?

Thanks Joe!!!!

I pumped until lube started pouring out the top. It took a lot of pumps for that to happen.

Anyone else change their own lower unit gear lube? I changed mine for the first time on my own today on my 2003 Yamaha V-Max vx250. When I looked it up, it's supposed to hold 38oz, but it only took...

Thanks guys! I'm going to dig into this in a few weeks.

Anyone out there had an issue with their livewell open/close valve? My 2003 Champion 206's doesn't seem to close, or has broken somehow. Any insight or help in what might be wrong before I remove my...

Anyone know what the accessory switch on a 2003 Champion 206 would have been hooked up to from the factory? The wire to mine was just laying in the bilge well not hooked up to anything. There was...

So I got out my volt tester. Turns out the following:

- there seems to be no power to the automatic bilge float switch wires(even when every switch on the panel is turned on)
- there is no power...

So I pulled all the batteries and moved the oil reservoir so I could drill new holes in the plate it sits on. Per Rixk's advice I checked the pumps. My pump out hadn't worked since I bought the boat...