1996 190DX, with 225 Mariner Magnum EFI, Fury 25P
PESTPRO
http://i28.tinypic.com/2qvbak7.jpg
Type: Posts; User: tigerholic
1996 190DX, with 225 Mariner Magnum EFI, Fury 25P
PESTPRO
http://i28.tinypic.com/2qvbak7.jpg
1996 190DX with 225 Mariner Magnum EFI, Fury 25P prop.http://i28.tinypic.com/2qvbak7.jpg
Thanks Champ...same too ya !
Thanks Lea...they should pay you for such good response !
I put my Champ in the shop today to have a foot switch for the powerpole installed in the bow....ADVICE...get the pro model powerpole if you...
Hey guys....I put drinks and a bag of ice in a rear-side compartment ( next to livewell ) of my 1996 190CX and when the day was over and i pulled the plug to drain that compartment, water started...
Just curious....what would brown water stains around transom bolts indicate ? Mine has stains about 3-4" long on the passenger side at very top corner.
Thanks,
PESTPRO
That's awesonme info that will come in very handy...thanks !!!
Thanks Kris...i will research the demensions of the 41 gallon tank...those 10 extra gallons would be nice to have !!
You're right Lea...it is 92" beam. I was going by what the previous owner had told me he thought it was, during our first meeting. And the original Texas title has the boat listed as a 1996 model...
This is all invaluable info THANKS GUYS !!
The 31 gallon tank i have is 59 1/2 " wide and 9 1/2" tall....and the compartment is 71" wide on interior. The beam is 84" wide and the boat is listed...
I took a 3 hours trip with 1/2 that time in idle zones...and approx. 120 miles on the 31 gallons my Champ holds....but anything over 4K rpm and i could watch the fuel guage moving !! That Mag III has...
Thanks LACHAMP...i was hoping to go witht e 8" model
These guys have been great at offering advice.....way better than i have been able to get locally over the phone or doing online research.....i have no doubts answers are on the way !!
Thanks...
...
Awesome...saved it in my favorites !!
THANKS !!
PESTPRO
Thanks Lea...any help is appreciated.
The only under seat storage is the middle of the bench seat....looks like a icecooler. Just solid hull under driver and passenger seat.
Maybe that's where i...
http://texasfishingforum.com/f...45158
The above link will show photos of my Champion 190 Elite with 225 Mariner Magnum 3.0 as it was advertized from the seller on a bass club chat room forum....
I'm about to equip my 96' Champion 190 Elite with a power pole and i'm looking at the less expensive 'sportsman" 8' mpdel.
Has anyone had experience with power poles on their boat and will the...
By the way Pat...i bought the boat from McCaney, Tx...near Odessa. The boat was purchased at West Texas Marine and titled with the 225 new, from there. The previous owner fished in a local club at...
You guys are right on and definatelly understand what was happening with my new Champion...thanks.
After reading some posts it was consistant that the jackplate setting should be 3 1/2" below...
It has a hydraulic jack plate that when it has the motor raised as far up as it will go, the center of hub is 3 1/2" below the lowest point of the hull under the drain plug.
And it gets dangerously...
1996 Champion with a 225 Mariner Magnum EFI, Trophy 25" prop, hydraulic jack plate.
Can't get but 5000 rpm and 60 mph on Hummingbird GPS out of her...and she runs perfect and strong....just serivced...