Update...
Ended up being a bad connection in the boat wiring harness.
Type: Posts; User: Nutoy
Update...
Ended up being a bad connection in the boat wiring harness.
I have looked and looked again and can't find anything unplugged.
It's possible I blew a fuse, but all the fuses I've checked are good.
No sir. No 1-6
I talked to another mechanic and he said the same. Possible a poor injector connection.
He recommended I unplug and replug all my injector connections.
Did that.
Now my...
Was idling out and my alarm started going off.
6 intermediate beeps
Smartcraft gauge info showed System Fault 26.
Hit info button,,, <Air Injector>,,, Direct Injector not working properly,,,...
If someone has a parts motor laying around.
I'm in need of the lower motor mount cover on a 2016 Mercury 250 Pro XS 2 stroke. Drivers side if it makes a difference.
2014 Phoenix 921 Pro XP
Been sitting a few years.
Located in East Tx.
$34,000
486925
You are looking for a Pro Kontrol handle.
They are no longer made, and hard to find.
I may have one buried around here somewhere. I'll see if I can locate it and let you know.
Which model?
I have several.
To get the system totally full of fluid, it helps to have someone help by working the trim up switch while you add fluid. I've found those little pump bottles work well for topping off the fluid....
Yes.
If it's not getting firm, try holding the bulb vertical with the outlet side of the bulb facing up.
It should be smooth when you turn the shaft.
Was there any metal debris on the drain plug magnet?
Hose length depends on the set up.
Lots of the newer boats have connection fittings at the splash well area that goes to the steering cylinder, then a different set of hose go to the helm.
Some...
Yes, the lower can cause a lose in RPM's. You may have a bearing seizing up due to the water.
If you are going to have a mechanic do the seals, you might as well have it taken down and inspected.If...
Seastar HC5345-3
This is partially true.
When replacing gears, be it all of them or just one, the shimming process must be completely redone. The same shims can not be reinstalled as they were before the repair....
If everything is trashed, it's going to be north of $1500 to get it repaired. Just the gear set is going to be around $900-$1000, and the major bearings is another $400, not to mention labor.
I...
I have a bunch of 2.6 Yamaha parts for FREE.
Early 90's carbed 225.
Complete motor, was running when pulled a couple years ago.
Couple of blocks.
Lower unit and Lower unit housing.
Reed...
Fixed it. Please delete.
No
Need a actuator motor if anyone has one laying around.
TIA
I have heard nothing but good on the Hydrotec guys.
Hopefully you'll get it taken care of in a timely manner.
You may want to reset the oil pump to break in mode.
Take it easy for a few hours changing the RPMs every few minutes, then run it like you stole it.
Sounds like somebody should have done a farther inspection when they were in there the last time.
Usually, if a bearing or gear fails, it will take out other bearings due to the metal shavings...
My '09 HPDI did the exact same thing. I thought it had blown the power head, but I figured it's already shot, so I idled back to the ramp. While idling,I noticed if I gave it a touch of throttle, the...
Do a Youtube search for Yamaha Outboard Tilt Trim diagnosing.
Several good videos on how to diagnose the problem.
If you are the least bit handy with tools, there is not much to the trim...