Cannon plug
key switch
neutral safety switch
solenoid
electrical connections
Type: Posts; User: lpugh
Cannon plug
key switch
neutral safety switch
solenoid
electrical connections
A small amount of stabilent 22 on all connections will solve the voltage drop issues, absolutely no aluminum anywhere in electrical circuits., it will self-anodize from the elements and become an...
If the amp draw from the steering exceeds about 1 to1.5 amps it may damage the control board. I do not know the exact spec for max draw, but I do know a good steering module under no load only pulls...
Who performed the injector service and was it a complete tear down of the rails as well, very important with compressor failures.
Voltage drop issue, Will require a DVOM and voltage drop test to pinpoint where the problem is. Start with a battery test and verify the correct battery is being uses
950 CCA with at least 185 min....
Kill switch
Also make sure the tri lobe pin is in place and the cross shaft has not shifted..
Pump up the primer bulb and try again, report back
Sure can
Pic please, need to see it. There may be a much better way, If flare out a die will not start. Need to use a small carbide die grinder first to retaper the end of the shaft and then clean it up with...
No posi loks, garbage for connectors, there will many long term problems with them, Already seeing issues with the sea clear installs.
Emergency quick fix only!
Bill research Hybrid system for batteries, this is an area I have a great deal of experience and training in, There are many benefits to Hybrid system for both batteries, Will not cause any harm to...
Put the large screen units on the bow where they are need the most, Thank me later.
Neither, just a higher capacity cranking battery, very few applications need a house battery, I have one customer that did need more power, set him up with hybrid system, a 125-ah ionic in parallel...
Do not need 10 gauge wire to each unit, run a twisted pair of 10 gauge to a fuse/buss box. Then run a 16 gauge to individual unit 9 or smaller, 14 gauge for larger units from the fuse box
Ritts dye, find a hidden spot to color match it on before using on the deck.
You may have to mix different colors to achieve the desired shade you need and dilute to lighten color
That is huge in making the final decision!
Techron or Quickleen work far better than Ring Free, over forty-years working with motors has proven this to me.
I Bleed black, but for a four stroke I lean strongly towards Yamaha. I would not touch a Suzuki, no dealers out here, to many issues and would kill resale value out here on a Bass boat. Mercury's...
Are you pumping the primer bulb up till firm. If not try this first and report back
Far more importent than what the spark plugs show!
Supicious of a ground connection between cranking and TM batteries, could very well be the charger
Absolutely will be a float switch or water in the bilge
Need rigid mounting as the special tool achieves, Do not attempt reuse diaphragms that are cupped and will not set in place properly!
I think is referring to left and right being reversed going south!