Search:

Yes sir I did buy an OEM Starter. So far so good!

Well after testing the voltage everywhere I figured out I was losing volts from the front to the back side of soleniod. I ended up just buying a complete new starter and it started right off... ...

I pulled it in the shop this morning, I think I am just going to have to work from my battery back and see where I am losing voltage. An amp meter would probably be helpful but I will start with my...

This group 27 battery is brand new

Sorry about the wrong forum!
As far as actual voltage with a multi meter at the battery with just the motor leads no accessories it was 12.6 when it would not start the motor just slowly turn the...

2011 175 Optimax Pro XS SS#1B847035
I bought this motor with low hours on it in 2012 and have 400ish on it now. I have always had a group 24 interstate cranking battery with the bilge also hooked...

Problem resolved! Thanks for the help! I installed the highspeed pickups and tore my lower unit apart again. I replaced the gaskets. I have more water pressure now than I have ever had. At WOT it got...

Thanks for all the help! My AAD boat is his V-bottom roughly an 8 degree all the way through the bottom. I ordered the scoops and gaskets from Don this morning so hopefully i can get them all...

Thanks for the help. I edited my post and put the serial number in the title sorry. I will call your parts department and get new gaskets ordered. Is there a downside to putting the high-speed water...

This problem got worse over the long weekend, by Sunday night. I couldn't hardly go above 2500 rpms without it getting warm. I replaced the thermostats tonight thinking they were just not opening up...

No problem, it could definitely be done without taking them off but i cleaned out my strainer so i had them off.

I took both lower plastic’s off and they were a piece of cake!

I did not have the same issue before but the weird thing is I barely had any pressure at idle and 7-9 at WOT before replacing the parts and now I have 5-7 at idle and 9 at 3300 but after i get over...

I wondered if that was what i should do.... What all does that kit consist of? I have seen where some people cover up the top two slots on their intake as well but i wasn't sure what exactly that did.

I have a 2011 Mercury 175 Pro XS (I forgot to write down the SS # I will get it tonight.)
I replaced the plugs and water pump housing, impeller, all gaskets and cleaned the strainer this winter and...