That story does not surprise me at all. I had the same experience with USAA on a totaled boat. Learned the hard way that with them a boat policy only applies when it is on the water. While on the...
Type: Posts; User: mdsmith
That story does not surprise me at all. I had the same experience with USAA on a totaled boat. Learned the hard way that with them a boat policy only applies when it is on the water. While on the...
Boat insurance. I went through Bob and got a policy with American Modern, but not willing to pay more for less.
Who do you use for insurance here in Virginia. I’m thinking it’s time for a change as my current insurer wants to increase my premiums and reduce coverage at the same time.
TIA,
Mike
Thanks guys. Both of those places are over an hour away. I would prefer someplace closer, but if there aren’t any options around here then I’ll have to check one of them out.
Hello,
I’m looking for someplace to get annual service done on my Mercury Optimax 150. I’m in Yorktown and used Nansemond Marine is Suffolk before but apparently their mechanic doesn’t work in the...
I use 303 Aerospace Protectant on the rubber and vinyl of my 2008 Z7 and no issues so far.
It helps lengthen service life of your hydraulic steering end cap seal by eliminating the wobble while towing in my opinion. For that reason alone ($100 repair) it pays for itself.
I use them when I want a little more depth without having to upsize in weight. Chatterbait brand rises in the water column for me on a steady retrieve unless I stop or alternate speeds which isn't...
I would say for a stock 2011 Z8, $28K is a little high but check NADA and see for yourself. In the boats4sell section there is a fully loaded 2014 for $28K.
Is it the trolling motor breaker? Without a pic or description of where the breaker is attached all responses would be pure speculation. My 2008 has a breaker on the charging side that went bad last...
https://www.walmart.com/ip/CORROSIONX-90101-Corrosion-Inhibitor-Penetrant-Lubricant/40738963?wmlspartner=wlpa&selectedSellerId=1122&adid=22222222228028245912&wl0=&wl1=g&wl2=m&wl3=60522090729&wl4=aud-2...
$8K in reels? That's more than all my gear combined. On the cheaper end, Lew's LFS reels will work for small cranks.
Try this site: http://tracnet.trackermarine.com/COPM/NewSerial01.shtm
Chris Lane used the new BP Titanium 8 Rod, 7'4" MH and a Johnny Morris Carbonlite reel 6.4:1 with braid if that helps.
It's definitely breaking at the knot if the end of the line is curled. Dead giveaway. Lots of good suggestions here and I would like to add that you should loosen you drag a touch to provide a little...
Strike King Series 4. I dislike the Bandits as they seem to spin too much on the cast and cause line twist.
You could use these doubled up to cover the rigging tube to stop the damaging rub...
Back spacing will be what makes the difference. If your current rims are "0" back spacing and you get a 5.5" "0" back spacing you should be good but if your wheels have any backspace you will rub...
Seriously? There are probably 100 threads on the Oznium lights.
I use a Trilene knot with no issues. I think a Palomar is more popular and recommended for braid.
Quit towing with a V-6, shift problem fixed.
Autozone, O'Reilly's, Napa, etc. pretty much any auto parts store carries submersible trailer lights.
It is very unlikely you are getting higher RPMs with a 24p vs a 21p. The 21p is smaller in diameter and will turn more to achieve the same speed. Going from a 3 blade to a 4 blade prop usually...
I used this site to get part numbers and stuff for mine.
http://ajaxtrailers.com/wp-content/uploads/2013/02/Section-I-Axle-components.pdf
If it's the single axle this might be what you need. The parts are what are on my '08 trailer for a Z-7.
Hub 13674 Depth 4"
Outer axle dia 1.05
Inner axle dia 1.37
Inner bearing L68149...