Search:

Type: Posts; User: Tx Champ

Page 1 of 20 1 2 3 4

Search: Search took 0.14 seconds.

  1. That might be an interesting solution and might...

    That might be an interesting solution and might not be that bad when you consider the price of the rocker switch, actuator and breaker, but it might take multiple switches for some functions that...
  2. Thread: seat pedestal

    by Tx Champ
    Replies
    4
    Views
    131

    Champion had a similar issue. I used a strap...

    Champion had a similar issue. I used a strap wrench from Lowe's or Sears. I then used a 2" Dewalt flap sander to take a very small amount of material out of the base. If you get too aggressive,...
  3. Replies
    4
    Views
    146

    If it's going in your dash, might try to find one...

    If it's going in your dash, might try to find one that matches your other gauges.
  4. Thread: Coffee Is Hot

    by Tx Champ
    Replies
    4
    Views
    25

    About time for :beers: :wink:

    About time for :beers: :wink:
  5. Ed, I have considered that. Here's what would...

    Ed, I have considered that. Here's what would have to happen.

    1. Replace the MegaLink controller with a breaker box. MegaLink has the breaker feature built in. I figure it would be roughly 30...
  6. Replies
    12
    Views
    541

    Same on my 07 210. Of course they moved the tank...

    Same on my 07 210. Of course they moved the tank forward to under and behind the seats. I think that has created a balance issue since it seems to be more sensitive to trim & speed more so than my...
  7. Thread: Lost My Phone

    by Tx Champ
    Replies
    5
    Views
    114

    :laugh:

    :laugh:
  8. Replies
    14
    Views
    125

    I doubt it matters. On my 210 the rear hatch has...

    I doubt it matters. On my 210 the rear hatch has the body attached to the lid. I only know this cause I've had that lid off a couple of times in the last month :ohwell:
  9. Replies
    14
    Views
    125

    Probably not, the lids on the boats I've had fit...

    Probably not, the lids on the boats I've had fit tight enough to keep them from trying to open on their own running down the lake. If anything, would just make them a little harder to close that...
  10. Replies
    14
    Views
    125

    20# I know was used throughout the 90s. SL-36...

    20# I know was used throughout the 90s. SL-36 was the part #, extended length 17 1/4" and collapsed 10 1/4". My bet is that it's just time for new ones.
  11. Thread: Sunday Coffee

    by Tx Champ
    Replies
    5
    Views
    76

    Mornin y'all ... thanks for the :mug: Jerry....

    Mornin y'all ... thanks for the :mug: Jerry. :smile:
  12. Replies
    1
    Views
    46

    Are they fuses or breakers? Pix would help. ...

    Are they fuses or breakers? Pix would help. Some tournament models had fuses, but Elites have breakers.
  13. Replies
    10
    Views
    97

    :mug: :thumb up2: :cold:

    :mug: :thumb up2: :cold:
  14. Replies
    6
    Views
    74

    Mornin all y'all :mug:

    Mornin all y'all :mug:
  15. Replies
    5
    Views
    223

    Here is a little older 90HP, but should be very...

    Here is a little older 90HP, but should be very similar. Since you don't know the last time it was changed, I'd get a complete kit and change everything. If your 50HP also has a pressure relief...
  16. That is what it looks like to me. In the...

    That is what it looks like to me. In the conversion instructions, that breaker was removed. So since you still have it, I assume it is replacing one of the fuses I have.
  17. Hmmm, there should have been 3 fuses back there. ...

    Hmmm, there should have been 3 fuses back there. 2 red leads and 1 brn/red, which I see yours are orange. Whoever installed the conversion may have used the 30A breaker for the other red lead since...
  18. That is correct for the functions labeled on the...

    That is correct for the functions labeled on the breaker panel, however there are 6 fuses in the conversion kit. 3 are behind the switch panel and are for the two timers and tilt/trim power to the...
  19. Tom, if your harness is like mine, there is a 6ga...

    Tom, if your harness is like mine, there is a 6ga red wire connected to the battery. About 8" back there is a 50A breaker. Off the opposite end of the breaker are 2 10ga wires. I told you all that...
  20. Replies
    5
    Views
    320

    Guess I set myself up for that one ... :doh:

    Guess I set myself up for that one ... :doh:
  21. Replies
    4
    Views
    145

    Llebroc makes a center box for the GT2 series...

    Llebroc makes a center box for the GT2 series seats that'll work with the other styles. Kinda pricey, but it's a first class box and tough enough to use as a step up to the rear deck. I removed my...
  22. Replies
    5
    Views
    320

    Bummer ... wonder where the community spread...

    Bummer ... wonder where the community spread started?

    https://tylerpaper.com/covid-19/wood-county-has-its-first-confirmed-coronavirus-case/article_e62a1a3a-7390-11ea-8200-3b9fddff8b1e.html
  23. Thread: Humpin Coffee

    by Tx Champ
    Replies
    6
    Views
    112

    Mornin y'all ... thanks for the :mug: WB ...

    Mornin y'all ... thanks for the :mug: WB :thumb up2:
  24. Replies
    10
    Views
    479

    Check with Carol Newnum at C&O Marine on the...

    Check with Carol Newnum at C&O Marine on the fenders.
  25. Taylor, just sent you a PM

    Taylor, just sent you a PM
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4