Don't worry about the fenders, watch the center bunk boards. You want the ends of them to be 1'-1.5' out of the water. No more no less.
Type: Posts; User: Blaine0311
Don't worry about the fenders, watch the center bunk boards. You want the ends of them to be 1'-1.5' out of the water. No more no less.
water level needs to be fully above the pumps for them to work correctly. these aren't high quality pumps, its more like a "water fan" than a pump.
have the mechanic pull the old impeller, if it is still in good shape just replace the impeller, if it has extra wear and tear on it, replace the entire pump.
basically you are judging the...
more question
im going to take it in and have the oil pump changed and a compression check done. since i bought this boat used from a dealer that got it at a repo auction, i have no information...
I've replaced the pump but its not getting power. Where is the fuse for it located? What else should I check?
im going over the trailer wiring to make sure all wires and grounds are good.
i am having this problem also with a 2003 ez loader. my reverse lights are working on the trailer. i think the tongue is too easy to push in. when the trailer is parked i can put my body weight...
my trailer is blowing fuses in my truck. im guessing this means there is a wire going to one of the lights that has rubbed through the insulation and is shorting out on the trailer?
i trim mine down against the transom saver until it touches, and then bump it down a little at a time until there is no more movement. i stop there.
what do you mean "return line"?
i called yamaha, they said that my outboard is one of those that needed the oil pump changed and it hasnt had it yet. maybe the oil pump is running too lean/rich...
ok, ill check that. i took it out again and narrowed the problem down further.
about half the time it runs just fine, idles normally and throttles up normally. the other half i have this...
same engine same prop, ran it this weekend with 3 guys, full live wells, full gas, full ice chests, 5600-5700 rpms @ 64-65 mph
skeeter zx 225
mine is a Rule Pro Series 500 GPH aerator. havent found anyone with that motor yet, seems like everyone has the tournament series.
I have the same boat and need to replace one of my aerators also. Let me know what you find out about that.
Well, this morning I ran it just fine for over an hour. I ran it in all RPM ranges. Then just when I went to the ramp to load it up it started acting up again.
Same thing, if I shift from...
I hooked the water hose up to mine today and ran it in the drive. It ran fine and wasn't missing or stalling out. I did pull the plugs and find some build up on them though. I'll take it to the...
who do you recommend for servicing a yamaha in san antonio?
I have the same motor and it did the same thing to me today.
It would idle rough like it was missing. Wouldn't throttle over 1600 rpms unless I put it in gear and floored it real quick like. ...