I have an unusual setup. I only have one charger connected to the start battery and then have a battery to battery charger to charge my deep cycles from the start battery only after it reaches a full...
Type: Posts; User: Trask55
I have an unusual setup. I only have one charger connected to the start battery and then have a battery to battery charger to charge my deep cycles from the start battery only after it reaches a full...
Does anyone make a powered jackplate with more that 12" of vertical travel that would handle a Mercury 175 Pro XS?
My motor is the XL and the Bay Kit will add another 5 inches. The mounting holes in the transom and motor will allow me to drop the motor an additional 2-3".
I have a 2012 Mercury Pro XS serial number 1B917726 with a jet pump installed on it in place of the prop lower unit. I would like to be able to switch between the jet pump and a prop lower unit...
Serial number is 1B917726, Model is 1175P83HY. Anybody know what the Mercury part number is for the waterpump rebuild kit. I live in Oregon and would like to pick one up locally so I can get back on...
Already replaced the thermostats and compressor strainer.
You solved my problem! PSI at idle is .3 to .5 psi and 8-9 psi at WOT. The motor is used and new to me so I have no idea when the pump was last replaced. Not sure why I would need a SN for a...
The tank is in the belly of the boat under the floor, holds 50 gallons. The tank fill is on top of the gunnel near the stern. I have yet to find a way to accurately tell how much fuel is left in the...
What should the cooling water pressure be at idle, middle throttle and WOT? After 15+ minutes at WOT then going back to idle the cooling water will start rising rapidly and exceed 190 degrees. When I...
I have a painted smooth sided aluminum boat and the gas tank vent is on the side of the boat near the stern. I've heard of and seen a overly full tank leaking fuel out of the vent when the weather is...
I have spent hours searching for a standalone digital fuel gauge that uses a fuel flow sensor rather than a in tank device. Something that would allow me to enter what I put into the tank and show...
I have spent hours searching for a standalone digital fuel gauge that uses a fuel flow sensor rather than a in tank device. Something that would allow me to enter what I put into the tank and show...
The 8080 panel comes with the switches (on, off) and are over $200. I already have switches (1, 2, combine, off) and just need the panel with the 3 5/8" holes in it.
I want to install a couple of the Blue Sea E series battery switches in my aluminum boat. I want to mount them in a panel rather than surface mounting or cutting any large holes in my boat for them....
I'm not concerned about a spark but rather a dead short and the battery cable turning into a 20 foot piece of red hot copper which could melt through the PVC conduit and potentially end up on top of...
I want to add a Garmin TR1 autopilot for the trolling motor and will need the space for the hydraulic pump in the rear so I need to relocate the starting battery forward.
I live on the west coast and have a aluminum Alumaweld 21' Columbia with a single battery in the aft mechanical compartment of the boat. I would like to add another battery or two but the aft...
I have a 2012 ProXS and it appears that oil has been leaking from the crankshaft seal under the flywheel. There has been enough of a leak the the starter and alternator has some oil in and on them....
I have a 2012 175 ProXS Optimax serial number 1B917726 with a jet pump. This is a XL 25" ProXS. I want to buy a prop lower unit for my motor too so I went to the mercury parts web page and plugged my...
I have a 2012 Mercury ProXS Optimax 175 serial number 1B917726. I bought this motor used with about 500 hours on it from a local Mercury dealer and had them install it on a new aluminum boat I...
Model number 1175P83HY, serial number 1B917726.
I originally posted this in the Mercury 2.0/2.4/2.5 High Performance section but think this would be a better place to ask my questions. I have a 2012 Mercury 175 Optimax ProXS model 1175P83HY serial...
I have a 2012 Mercury 175 Optimax ProXS model 1175P83HY serial 1B917726. This motor has the big tiller steering and a jet pump installed on it. The boat the motor its mounted on has no gauges except...
I'm not looking to fully charge the batteries while towing and will top the batteries off when I get home after each trip. Round trip road time will usually be 2-3 hours. I have a 2000 F350 and have...
I'm looking for a online source of Anderson type connectors in both panel mount and waterproof/resistant that will handle 12VDC loads in the 40A to 50A range. I've gone to the Anderson website but...
