do you have another crank position sensor to try ???? is the paint good on flywheel /no rust on teeth
Type: Posts; User: JOE54
do you have another crank position sensor to try ???? is the paint good on flywheel /no rust on teeth
pmed ya .... interrested
recommend replacing all components, inspect cyl closely for any scaring also:rolleyes:
yes sir must have batt voltage to run ,never disconnect batt with it running
we have seen some yes especially on boats that set for extended periods of time
:thumb up2: report back
+1 right there
pull the reed plate check it out the tiniest speck can cause reed stuck open
sure could be i hate um , unlikely PCM is your culprit , be sure you look at the connector for the main power relay for burned or melting connections
QL77CC Champion ?????
absolutely, positively sure can.... most of the time its #6 unlikely #2 i would look more towards that cyl being lean from inj problems do a search on here "cold seize" youll find plenty of info
unlikely its a plug wire check they compression then borescope cyl and verify sleeve position is correct
250xb then :thumb up2:
built 10/14/17 registered 3/16/18 no warranty work preformed
would also do a fuel psi test when its under load and surging
opti should be 30.L , no swapping wont fit , was block ruined on EFI????
HP rating on 901 ???
engine connection under cowl from key switch , also wiggle every wire and connection under there on stbd side including main power relay plug
if hose to tank to bulb is good (usually 3/8 black fuel line ) most can be reused when cut prior to bulb barb fitting
infared temp gun , :smile: it wont believe me
sounds like loose connection , do you have a battery switch in bilge compartment , verify 12v at solenoid and batt grnd connections under cowling , do all pumps /lights switches work on boat, main...
man thats great , did you advise him your engine is a tiller handle not a remote control model
ive got one laying right here now with cowling off and has no fuse , elec start tiller handle
huh that will sho cause it right there , good ol folded liner , lucky didnt loose a powerhead , real lucky
:thumb up2: put it on muffs should be fine , idle speed only no reving now:mad: can damage gearcase
