Search:

#1B703690 I ran about 5 miles 5500rpm everything was sounding great but when I let off the throttle the engine died. Now it starts and runs very rough but dies in 5-10 seconds. The primer bulb is...

I have a 3 blade fury or a tempest is one better than the other for bow lift? I switched to lithium and now seems to need more lift up front. thanks

I need to get a new prop for my 36 volt 112 ultrex and need to know what model is needed so I can order one. thanks

looking for some advic. I have never had birds so know nothing about them so looking for advice on what I should get to run dedicated 360 on bow. Solix vs Helix and I am assumeing MEGA is better....

1934 Ford three window chop top ZZTOP coupe, and it is in my garage!

I have a 2009 Z520 and the stock back up lights are worthless. Has anybody came up with a good aftermarket fix that looks good? trying to get suggestions. thanks Rusty

Just wondering where people are mounting active target box in 2008 Z520 with ice chest between rod iocker and driver consol. thanks in advance Rusty

what do I need to mount a AI2 3-in-1 transducer to 36 volt ultrex with built in sonar? thanks in advance

look at golf shops they have different size tubes for golf bags that work good.

brand new Mercury

all 3 were new complete lower units. 1 broke a shaft, other two siesed up, and keep losing seals

pro xs 250 serial number 1B703690 I only have 355 hours on motor and just broke my 3rd lower unit. is there any other options available? have not hit anything with any of the three that broke. any...

Can I adjust the date? Seems to be stuck on year 2000

I could feel the shake at my house in Madera

thinking about relocating around lake fork any area I should avoid? would love to have my own dock/boathouse. thanks for any advise

thumbs up

does anyone know if mounting holes for motorguide tour 109 will work with a new ultrex hoping not to have to drill more holes. thanks

is it common for the surge brakes to jerk hard on take off. the fluid is not low and no air in lines. model#70LP from tie down engineering. thanks

if i replace a motorguide tour 109 with a new ultrex does it use the same mounting bolt pattern or does it require new holes in boat?

does anybody know if a new ultrex foot pedel will fit into a 2008 z520 recess cut out? thanks

2008 250 pro xs lower unit was replaced and I would like to confirm which one it is. new unit has #8M0072949 sticker on it. thanks

winner winner chicken dinner!

owner z520

Mark- If you drive hwy101 north to San Francisco you drive by Tackle Warehouse in San Luis Obispo.

I am getting water in the locker in front ice chest. Think it needs to be resealed behind rub rail any advise n how to do this would be welcomed. The boat is a 2009 Z520. thanks in advance Rusty