Restore sonar-defaults and set it up again.
Type: Posts; User: Team Colibri
Restore sonar-defaults and set it up again.
Yes. Even to non-Lowrance units, as most of the NMEA-sentences used are generic.
1. Test with another (know good) transducer.
2. Save waypoints and do a hard reset.
It is on 9 vs 9, so I would expect it to be on 7 vs 7 as well.
Lowrance units showing incorrect suply-voltage is by no means normal, issues in electrical systems causing voltage drop is VERY normal. As long as your units have updated software, you can safely...
You should never assume that anything not mounted by you is mounted like it should. :) Especially when it comes to headingsensors (like your P1) and transducers, as mounting this perfectly requires...
Your SS 3D module connects to your unit with ethernet, the yellow-ish connector on your unit. I have no idea what you mean by power wire to the structure inlet, you should not have anything...
As Gen 3 can only handle one 2D-transducer, I知 going to guess that your TotalScan is really an LSS-2. :) If it is not, you can simply use the 2D from your TotalScan by selecting m/h TotalScan as...
Minor updates will never be available through WIFI, only the major ones.
Some updates require a large update-file, those will not load over WIFI unless you have a memorycard in the unit for storing...
I have VV Link in combination with various units, but I have never looked for water-pressure. I`ll check the next time I`m on the water.
A screenshot or three would be a good idea here. :)
Is "Guide Trail Chips" a map or a bunch of trails you have imported to your unit?
Is it your position or your heading you find incorrect?
...
Check the module and see if it has power and that the yellow wire is connected as it should.
Assuming that your AT is the first generation, make sure the module and your unit is running the latest...
Yes it will.
The lines are probably ringing from your jackplate.
I知 guessing you mean the TM from Power Pole called the Move. That comes with a Navico HDI transducer built in. I知 guessing it has the 9-pin connector, in which case you will need adapter SKU...
The horisontal lines on the HDS Live are typically related to incorrect mounting of the transducer, the vertical drops on the Gen 3 is typically related to running two transducer at similar frequency...
Add water and a few fish. :)
The 2D-element in the AI 3i1 is paused with standby, other channels like AT and StructureScan must be stopped (Menu-More options Stop sonar, for each channel.)
Anyone with more than 50 waypoints should take a serious look at Reefmaster, it is a fantastic piece of software for waypoint-management.
This means that the update changed source-setup in the unit, and thus the unit wants to do a search across the network to find any potential sources. The same thing you can do manually through...
AT2 and AT1 are inter-changeable so he can buy the AT2-transducer and use with his AT1-module.
Personally I turn it off, only to avoid the pop-up telling me the unit has connect or disconnected. I highly recommend that you do all softwareupdates using a PC and memorycard, and with that in mind...
Puls on AT typically means you have another transducer running that you need to stop.
I use my TM as a TM, so I have my transducers on a transducer-pole. :)
This is basically the same with any electronic product you buy. They can be repaired, as long as there are parts available and you are willing to pay the cost. Several options out there that repair...
Lowrance transducer compability (bbcboards.net)
All 83/200-based transducers from Lowrance can be used with chirp as long as the unit supports it (something your Gen 3 does). Follow the link for...
