Search:

In my racor fuel/water sep on my boat I found this waxy junk in the filter. Only around 150 gallons through this filter, this filter installed new Sept of last year, and I haven't run the boat that...

Have a 2 stroke carb'd oil injected dt140, turns over great but won't start, continuous beeping from binnacle when ignition key is in 'on' position has good compression on all 4 (125+) and spark,...

Yep, that's what the mob+ does, it's a replacement for the binnacle kill switch (https://www.fellmarine.com). What I'm trying to determine, is can I bypass the binnacle kill switch altogether, or...

Thanks, what I'm trying to figure is, is the evinrude kill switch tied to the key switch cut off? I'm fine not using the existing kill switch anymore, that thing is always popping off, really...

Have a 2001 model RE200FXSIF , has anyone installed one of the fell marine mob+ units on this model year engine? My main question is, it looks like it's pretty straightforward wiring, but do the mob+...

Thanks, I'll take a look at the shift lever, lower unit gear case oil was recently replaced also, but I'll check it as well.

Hi,

Have a 2001 model RE200FXSIF , binnacle is hard shifting, it will shift and advance throttle, it's just very tight, gets worse as motor warms up it seems like. Very hard to shift out of...

Hi all, went to look at this motor today for possible parts/backup unit to a nearly identical 2001 I own. This motor had been sitting for approx 2 years, and was seized. Left without purchasing, but...

Hi, looking at a used '83 15 hp 2 stroke yamaha, besides compression, what else should I check? Were these year motors known to be good/bad?

Thanks!

Have a 2001 RE200FXSIF, recently installed a new fuel tank in my boat. Just wanted to confirm if there'd be any issues using an anti-siphon valve fitting at the tank? This was recommended by the fuel...

Yes, I was told when I purchased this motor (July of this year), that the EMM had been replaced once before, (one reason it seemed a good deal at the time) and the codes are there that support this....

Hm, so possibly nothing wrong with the oil injector/lift pump I swapped out yesterday. Does holding the oil injector on for too long damage it? Still proceeding with getting the EMM checked out /...

Thanks Seahorse, good to know. Well, dang. EMM repair sounds like my plan for Monday.

Code 34 before swapping new oil lift pump + injector in. No codes afterwards, just cuts off after 15 secs. Sigh. Guess I'll call marine computer supply monday am and see what they think.

Welp, installed new (used) oil injector + lift pump last night, labeled hoses, got everything all connected back up. Normal led start sequence on dash gauge, still starts and runs exactly 15 secs and...

Cool, thanks for the info. The cutting off after exactly 15 secs with no warning leds or beeps on check gauge I thought was odd, is this the emm shutting the engine off to prevent damage?

Are the oil injectors usually reliable? If I put a used one on, can I expect a reasonable lifetime out of it?
Anything I need to watch for on removal / installation ?

Hi all,

Have a 2001 model RE200FXSIF, running at wot today, dropped to idle, 'no oil' light on gauge, luckily I was within couple hundred yards of dock. Engine would still start and idle. (limp...

Ok, got my codes just now with wot link and check gauge procedure,
25
43
22
28
I've never cleared or checked the codes before ... assuming these are in order of oldest to newest top down? I know...

Thanks for info, outboardbooks.com doesn't have one for mine, parts catalog and operator manual is all they show.

Lots of 2005's on ebay, if anyone has pointers on where to find a 2001 service manual for 200hp ficht ram?

Hi all, had my 2001 model # RE200FXSIF out today for first longer saltwater trip in gulf, 6-7 hrs, 60 % trolling, 40% cruising around to some spots offshore.

Running great idling and cruising all...

Don't see a radio forum, sorry if this is wrong place, I have an older standard eclipse fixed mount vhf radio, that doesn't seem to transmit on ch 27 or 28. Other channels (16,9,78a) work fine. I've...

Great deal, got mine ordered, thanks for posting!!

sigh, murphys law of 12v grounds strikes again. Was really throwing me for a loop, motor was acting just like you turned off the key. No warning lights, no overheat, no oil alarm, just turned off....