Came back from a 12 day vacation fishing trip, cleaned the boat, put it away and three days later when fishing a local derby night my keypad wouldn't power up. No live wells, pumps etc. All fuses are...
Type: Posts; User: jhayford13
Came back from a 12 day vacation fishing trip, cleaned the boat, put it away and three days later when fishing a local derby night my keypad wouldn't power up. No live wells, pumps etc. All fuses are...
I did- 200 grit sand paper to remove the glue residue where the original transducer was mounted.
2017 Z20 bought in September of 2017. No accidents, never hit anything and it excellent condition. Last week my shoot thru hull transducer began showing a poor image so I removed the batteries and...
Here is what I found:
I disconnected everything and started back over reconnecting everything one step at a time.
All the other multiple attempts by myself and with Garmin Support, I was going...
Will do. I’ll report back. Thanks
The UHD is plugged into the 1042 at the console. The 1042 and 1242 are networked together. Prior to putting the UHD on yesterday, again, the 1042 had the GT15/30 hooked up and never had the issue on...
Thanks for the response. Yes, I have done what you mentioned numerous times. The 34 is listed as GCV20. I can get it to switch in SideVu but not DownVu. I’ve powered down, reset to factory, Garmin...
1042-console GT15 in hull and GT34/UHD black box connected to the 1042
1242- bow with CV52 on trolling motor networked together. The 1242 is picking up and showing GCV 20. I was able to switch back...
What about a 4 bank charger that is using the perko switch? I have 36 volts for the TM and then the cranking battery with my on board charger doing all of them. I am thinking I am getting...
The tech that soldered the wire in the foot pedal and placed the new magnetic switch in? Issue started previous to it. The thing is that when I first deployed the trolling motor and started...
I did all the work and inspected every wire, cord etc. I disconnected all networks cables in the testing. No screw holes etc.
I ran 10 gauge marine wire for all
30amp fuse on the battery
Ran 10 gauge from the bow to the battery as well.
Ferrite rings are on everything- starting and stopping points of graphs, transducers,...
Garmin transducers, cranking new battery but wired to that battery through a terminal block, 10 gauge new wire with a 30amp breaker at the new battery. Tried multiple transducers, pulled all wires...
Fuses and all connections good? All your batteries connected and paralleled together right? Did you try re-pairing it to the puck and remote. I had something similar with a Terrova once and it fixed...
I did test it and tested the new one as well that I installed. Wish it would have been that. Thanks though
Check your steering cables. Also, see if you can still steer with your remote.
Yes, three different transducers. Ran all transducer wires on the deck of the boat to test as well as hung them over the side which shows that the interference is from the Ultrex. Never had it...
Did that. It is for sure isolated in the trolling motor somewhere.
My Ultrex is a year and half old. Last fall just before ice came, my local BPS replaced the steering cables. After the steering cables, anytime the spot lock is engaged and the pedal bottoms out(only...
Thanks, I watched these earlier and had no idea about the fuse inside the Ultrex head. I will be sure to check that tomorrow. As far as grounding the TM, I read that it’s a big no no for the Ultrex....
The LS is connected by a data cable which you will have enough ports for. You will then connect your 10 and 12 together and can view the same on both. I have 1042, 1242 and 1022 with buttons. The...
Yes, I removed the 52. I was trying to give a description that would help eliminate when and where the problem may have started. The interference is at its worst is when the trolling motor is...
Hello,
I live in Michigan and recently added a GPS 1022, Livescope, GCV 20 black box with a GT34UHD on the barrel of an Ultrex. Prior to these additions I had a PSS22, GPS 1242 with a 52...
They are clueless since I had to show them how to recalibrate it. Any idea about index or how to?
Had BPS authorized MK dealer replace the older style steering cables and now when on spot lock and it gets all way to the left, shuts off. They have no idea and after much research I thought it...