Thank you, Sir!
Type: Posts; User: Paladin
Thank you, Sir!
Good morning. I am assembling a Starter Kit as a gift for a youngster. His dad is not a fisherman nor familiar with rigging techniques. There are a few illustrations on the Yamamoto page, but I'm...
I recently added two Lowrance HDS LIVE 12s, one LIVE 9, and a GHOST. Adding in AT and well pumps, I am calculating approximately 18 amps. Not wanting to swap out to lithium just yet, I am looking for...
I have 2 HDS GEN3 9s that I need to erase data from, including waypoints before I sell them. Is it safe to use a jump box to power up the units when doing so? Can I connect black to black and red to...
Hello friends. I've just replaced my GEN 3 HDS 9s on my Ranger with 2 HDS 12 Lives, one at console and one at the bow and one HDS 9 Live at the bow for mapping. In which unit is best to place my...
Looks similar in design to a Defiant, only smaller.
Thank you, Sir!
I am curious whether anyone leaves a quick-ink attached to their bow eye all the time to aid in connecting a safety cable after loading the boat. What has been your experience in doing so? I found...
Thanks everyone
Greetings from Connecticut. Does anyone know who the narrator was for the original TNN the Bassmasters Television show? I do not mean Bob Cobb, I'm talking about the VoiceOver narration off camera...
Looking for a source to purchase a few machine screws to replace some that backed out and have gone missing. Thank you! 497017
I recently replaced both bushings on my 2013 Z518 and am surprised at the amount of side-to-side play. It wobbles as bad as before I replaced the bushings. Does the duct tape hack work? Over time...
Thank you!
It was the live feed of DD
I don't know if video is available from MLF
Whatever it was that caused this, the creaking was very loud. Others with the same motor, during same airing made no noise...
I've been watching todays coverage and on DD boat there is a lot of CREAKING that can easily be heard. Is that noise possibly coming from the Lowrance Ghost trolling motor, do you think? Anyone...
Thank you! TC
Good afternoon folks
Recently I began getting notifications for pending uploads/downloads also called transfers. Two pics attached. On the water I have no access to wifi so I can't act on the...
I called Ranger parts with my HULL vin#. While they were easy to install on my 2013; the pedestals are still a little loose / wobbly. Slightly disappointed that they're not more upright and rigid.
Any experiences to share with using the TH Z-Launch? I am considering buying one. Thanks.
2013 Ranger Z 518 dual axle trailer
Thank you!
Evinrude 2+4 with every fill up. xD 100 oil
So, as follow up the Platinum Certified Dealer also could not get the engine to replicate the problem in his shop but is aware of a circumstance where this situation has presented with Evinrude...
Can someone advise me if the corner trays and the rear battery compartment trays will fit a Ranger Z518?
Thank you allhttp://www.bbcboards.net/attachment.php?attachmentid=341344&stc=1
Thank you Sir! I have appointment tomorrow with Platinum Certified Dealer
Yes the control is flush mounted. Installed at factory by Ranger. Lower unit has never been off of the engine. Engine has been 100% flawless for five years. Warranty thru April 2019.
Harvey Knight North Jersey Marine