this is what you want on that combo, I have same setup but mine is a 92 so it’s a little lighter but would run 82-84 solo light fishing load or 79-80 with two and full fuel. Those 2.5’s will turn...
Type: Posts; User: sv10001975
this is what you want on that combo, I have same setup but mine is a 92 so it’s a little lighter but would run 82-84 solo light fishing load or 79-80 with two and full fuel. Those 2.5’s will turn...
The new ProXS I had ran ok until around 35 hours, then you could really tell it was broke it. It picked up 2-300 rpm and mph, holeshot was much better as well around this time. It was enough...
Island cove is great if you want to fish that end. Nothing fancy, but clean and affordable. The boat slip is nice too and makes things easy after a long day of fishing.
I ran a 27 bravo Xs with the tube for a little while and it was by far the best overall prop I have run. After removing the tube I’ve ran several more over hub props and the only thing that ran...
Just wondering if anyone has tried to run a Bravo XS on a 20xrd/225 promax combo with the exhaust tube removed? Was wondering if this prop combo would work with a drilled midsection with the 8 pvs...
I ran a 27 xs on mine for a little bit and it was a great combo, ran 82-84 depending on load and was great to fish with. It was on a 20xrd/225 promax. 28 wouldn't be totally out of line and would...
PM sent
I previously owned a 150 proxs and it was a great motor, but I look and researched it and there is basically nothing you can do to them other than tweak props and reduce boat weight. The best power...
Not sure, that doesn't ring a bell but may be.
Please delete
The extra cup will help with both of your issues, I would hold off on the skid planer until you get prop worked. If you need a foil, I would use one like the Bullets guys run.
It's not turning 6200, those ois motors will limit rpm before then. New tach needed
I recently had the bearing carrier nut come loose and carrier backed out and turned about 90 degrees and damage the outer portion of threads. Was wondering get if anyone has used the thread chaser...
Found one, thanks bbc
Sounds good, just let me know
Hoping someone may have one they would be interested in selling.
8M0116274
The part number on bottle is not on the attached link
Was at Walmart tonight and noticed the label had been changed on the premium plus to advance premium plus and was wondering if any changes had been made. Best I can remember the part number has been...
I have a Fortrex and like it, the only issue I have is the height. It's just hard to see over running down the lake.
There is a small island down by dam that is usually good for a couple fish this time of year as well.
You are correct, especially up the river and in the back water!!!
Tough lake to fish, small baits usually work such as shakeyhead or 3/16 jigs. If cranking, shad rap but make sure it's not bouncing off bottom because they want hit it.
The small vent holes may not work for all set ups, so if you need the pvs holes added and pay shipping both ways you could buy a razor3. Also mark will trade it out if pitch isn't right and get you...
I mostly fish, so for that I wouldn't have a dual console. It's much easier to flip fish in the boat without the additional console and my rods are beating on it either.