I was running the existing wiring to my front bow 9sv but the voltage was low so I ran a new 14ga wire straight from cranking battery to bow 93sv and it got higher voltage and cleared up my picture.
Type: Posts; User: Matt_Fisherman
I was running the existing wiring to my front bow 9sv but the voltage was low so I ran a new 14ga wire straight from cranking battery to bow 93sv and it got higher voltage and cleared up my picture.
Does anyone use a screen protector or case for their remote? thanks
I installed Garmin Force on my 1990 Ranger and it has an angle. Doesn't seem to affect anything on the water.
Do you have a local trailer shop you can go to? I just went through all of this with my 1990 Ranger trailer and ended up at a local trailer shop called https://www.crofttrailer.com/
I saved a ton...
I tried every forum suggestion. Youtube video. Old wives tale. Finally said F this and bought the Garmin Force. Expensive but worth the money, now I can enjoy fishing again.
I fought this all last season finally upgraded to Garmin Force. All interference is gone. Good luck.
https://www.youtube.com/watch?v=6bzLo4Zt2ag
https://www.thehulltruth.com/marine-electronics-forum/1248670-trolling-motor-interference.html
It's weird once it is tapped into the hub it is loose inside and can move freely but can't be taken out of the hub itself without prying. It comes out about 1/4 inch of the hub and gets stopped.
thank you
I have the correct grease seal from Ranger. When I go to install the grease seal i tap it in flush to the hub like i have with past trailers and I can litetally pull it out by hand. Anyone ever...
Thank you I will do that. Do your inner bearing seals sit flush to the hub or do they go in a bit to finally stay in. I can literally pull them out by hand when I only put them in flush with the...
Do the inner seals sit flush to the back of the hub when installing or do you have to tap them down a bit in the hub they to finally grab.
1990 Ranger Trailer EZ hub system with the flush mount hole in the center of the hub. I have the needle attachment for my grease gun. Whenever I try to put grease in, the grease just shoots out the...
Do you buy your seals from Ranger?
thanks!
thank you!
1990 Ranger 393v trailer bearings question. I get out 10-15 times a year. How often should I be repacking the bearings? When I repack them do I need to order new bearings and seals each time? Thanks...
1990 Ranger 393v trailer bearings question. I get out 10-15 times a year. How often should I be repacking the bearings? When I repack them do I need to order new bearings and seals each time? ...
Correct
Agree
I agree with Robert Breaker on that. These videos are to help others learn.
https://www.youtube.com/watch?v=O03M14XHibw&t=2658s
https://www.youtube.com/watch?v=fVMJMaGVnUU
https://www.youtube.com/watch?v=R9nVItJl63s&t=2481s