If you can post a picture of the part you are looking for. Maybe I have one in the shop. I am not sure what you need based on your description. The Parts are very hard to find. You might get lucky on...
Type: Posts; User: Bradrodfish
If you can post a picture of the part you are looking for. Maybe I have one in the shop. I am not sure what you need based on your description. The Parts are very hard to find. You might get lucky on...
It should not be very hard to operate. The only adjustment is to take the push button off and then raise the reed switch up a fraction. You have to be careful with this adjustment because if it is...
Ok. Looks Like you know something about power. It is best to check the steering system with the remote. It will be much easier. You did say it does not steer in either direction with the foot pedal...
:thumb up2:
Remove the cover. Line it up with the lower. Reinstall the cover.
You have either a bad steering module or a bad control board or both. It is best to bring to an ASC.
The only thing I would be concern about is the corrosion of the inside of the part where the prop shaft seals sit. With time it could cause water to enter the motor assembly. Uless you want to change...
HUMM. Electric Engernear. This job may be far above your means.:laugh::nanner:
Did you buy it new or used?
What I am seeing here is a classic sign of oxidation(corrosion) on aluminum. I see it a lot here in South Louisiana. It is hard to stop it. That is pretty bad. It will...
Well I would say that if you did not find a Utube video it is because it is not easy. You have to remove the foot pedal cables and the head of the troll motor to replace. My advise is to bring it to...
Have you checked your batteries? They all should be load tested to find a bad one. Also check all connections for corrosion and tightness. 38 volt just means that you can read a voltage, but when you...
The Raptors come with two remotes along with the hardware to mount them at the console or use with a lanyard.
You either have the pivot bushings out or you have a twist in the mount. Look at the upper arm and see if there are any rub marks on one side or the other. Remove the side plates and to the rear of...
Not a concern. It is from the spring that is on the seal where the armature shaft goes through it.
As fa as paint, I use Krylon flat black for exterior use.. Just get a good solvent and clean the...
If you look at the pump diagram then you will see the up and down.Diagram#1. From my perspective if you look at the Raptor diagram #2 the bottom connect will extend the Raptor and the top will...
I have read that some of the motors do this. I have not run across this in my shop. I have no explanation as to why it happens. I could compare this to an airplane prop that whines when it spins up....
As Wayne said you do not need the heading sensor for GPS Spotlock. It does nothing but help you if you are using the jogging feature and is only for the jogging feature.
Back to the troll motor. If...
No data on that, but it will be a difference in speed, how much:confused2:
@ Wayne Thanks for the info and making me aware of the different models. With my head buried in repairs it is hard to keep up with new developments. With the blink of an eye it changes.:thumb...
You are the first that I have heard the boat scale adjustment did not help. This much I have learned. Small light aluminum boat will have problems with spot lock because of the size and lightness of...
Agree with you Mike. Not a sensor board problem is he can't steer with remote or foot pedal.
Yes they are, but all the other parts except the armature are NLA with Motor Guide. Best bet is E-Bay, but I heard there is a place in Missouri that has parts. I will see if I can find the name. It...
As I stated and wanted to add. the reason why the cable cover breaks is because the old wire jackets that came on foot pedal troll motors pre 2019 would get stiff when it got cold. That stiffness...
They did but they still have an internal 3 amp fuse that will blow when the steering module goes bad. Then you have to replace both. The quest has a 10 amp fuse internal, but the new steer motor is...
I must say that the newer ones are much more reliable than the older models, but the older models had a few issues. The new quest is almost sailer proof. You navy guys may now what i am talking about.