Below is a video of a cold start and warmup. Notice the stumbling early on and scattered through out, but especially a few harder stumbles at 1:54-2:06. If those stumbles are just a little bit more...
Type: Posts; User: greeneb
Below is a video of a cold start and warmup. Notice the stumbling early on and scattered through out, but especially a few harder stumbles at 1:54-2:06. If those stumbles are just a little bit more...
It seems that something is still not right. I have a new set of plugs, properly gapped and also had the direct injectors flow tested and cleaned. No issues found with direct injectors btw. Ran it...
Thanks Don. Got a new set of plugs on the way. We ran it a decent amount the last few days and it still doesn't run smooth at idle. Is it possible that a piece of the air diaphragm found it's way...
Don, ok got air diaphragm replaced as it was blown pretty bad. Had a good dealer do the work. He said everything looked good for pressures and no other issues found.
He did warn me that it was...
Ok, finally was able to do a little troubleshooting. Belt, tensioner, air compressor are good.
Fuel pressure is not good. As a matter of fact I heard loud air sounds from back of motor and...
2015 200 Pro XS - 2B117555
I ran to a different spot yesterday with no issues. Fished for a bit then went to move and the motor would sorta start, run really rough almost like chugging then die. ...
Be careful. I ordered a set of organic from Oreilly's and they will not work! So everyone that says just get the organic pads for Kia Sephia, just fyi, not all of them work. They interfere with...
I echo the posts above. Exact same results from my 819. 3.25" PTP and learn to drive it. It will take more trim than I was lead to believe.
Once I could drive it, I couldn't get near the...
Check your jackplate bolts. Mine were leaking. Found by backing the boat in at the ramp still connected to the winch and going head first into the back area. Sealed with 4200 and stopped it. Just...
Same here. 819 with 112 Ultrex. No regrets at all.
Is it pooling on the top of the tank where the remote fill hose comes in? If so, but sure to check the lines that go up to the remote fill cap area. Not the big hose that goes to the remote fill...
Mine really likes to sit at that 1/2 tank area for a while. I agree with Fidge, best way to know what you got is to fill it up again and figure it out.
War Eagle!
I have one that's a little tight. Are you opening them slightly and "tapping" the edge to slightly "adjust" the hinge back a little.
From the factory my motor was too deep and had tons of walk(over 4" PTP). Moved it up and man what a difference. Settled on 3.25" PTP.
On Helix you will need a map card in each one unless something has changed recently.
I had a couple of rings made to "reduce" the size of the hole to match the MercMonitor.
24 Fury 3 blade is where I would start.
Since I am betting the code base is almost identical, yes I think it could happen on any of them.
Be aware. I have gotten into a situation where my Helix 10 DI has lost the express menu when my Ultrex is connected to the network. I have contacted HB and they claim they have reproduced the...
As a boat captain for the last two years for a high school team, I am all for limiting the size of tourneys. I believe it is out of control. We NEVER fish a tournament that is under 225 boats, and...
I would replace both thermostats and be done with it. Especially if they are original.
I have tried a 25 Fury on my 819, but went back to the 24. Better holeshot with load and RPMs closer to max.
EG
Recently upgraded to Ultrex, already had Lakemaster and HBs. First trip out my HB lost the ability to show the X-press menu on the bow unit in one view. Nothing will bring it back so I completely...
Amen. It is absolutely ridiculous. Can't even get a parking spot to enjoy our natural resources.