Didn't know this update has come out for Helix G2 units. I'll give it a try shortly. Thanks!
Type: Posts; User: AdamW
Didn't know this update has come out for Helix G2 units. I'll give it a try shortly. Thanks!
It shouldn't. I've done it and I've heard of others having to do it.
Thank you John.
Thank you for the reply. Is the digital board in the head unit of the motor? I don't recall seeing anything like that when looking at the wiring under the pedal.
Hi.
I have an older 82lb 24V MotorGuide Digital Tour. Serial: 9B655880; Part No: 9BT52GCAF
Yesterday something happened and now the trolling motor stays on all the time at 100% power. I was...
Impressive!
Changing prop pitch can make quite a big difference. Talk to a prop-shop and say you want to get out of the hole quicker for pulling up skiers. They will ask what prop is on the boat now ... so...
:roll:
I think he only has an issue with constant. Constant is only working for him when the button is pressed.
OK. Thank you very much!
:smile:
Thank you for the input. The older Motorguide Digital Tour I have has a black plug. It may be pre-Lowrance and what I ordered last week is the current Lowrance plug.
It looks to me from that link...
Hi.
I recently picked up a used Motorguide 82lb 24Volt Digital Tour. I purchased online the Motorguide Sonar Adapter for Humminbird 7-Pin. I have a Helix 7 G2N. I went to plug in the new...
Damn!
:laugh:
I just use Indoor/Outdoor Roberts 6700 Carpet Glue from Home Depot. Works great.
Hello,
I have a Group 31 12V deep cycle battery currently that I've used the past year on my Minn Kota 55lb 12V trolling motor.
I just picked up a used Motorguide 82lb 24V trolling motor so I...
Impressive!
Man ... those are crazy expensive!
A related question ....
If using the newer Helix DI unit for ice fishing, you can vertical jig ... but you need the ice transducer? Is that true?
I have a setup similar to yours.
I have the transducer on my transom connected to the unit at my console.
I have the transducer on my trolling motor connected to the unit at the bow.
I have one...
Dig the foam out, reinforce the the hidden/inside part of the transom where the ladder is and reattach with larger bolts (with washers on the inside). Use marine grade caulking when you put the new...
So I got the pieces installed. Went pretty good actually.
Because I replaced the casting deck wood with new wood (old was was starting to rot ... which I didn't realize until I pulled it out), I...
Would you say that in a way you grounded it then?
Nope. The plywood floor goes across the entire available area to give a completely carpeted area. As done in the factory, the carpet wraps around the entire perimeter and is stapled to the...
Thanks again for input.
If I use a soldering iron, then the screws will be visible. The factory install had the screws under the carpet and completely hidden. It looked like the screws were put...