Good Morning. I wanted to get some opinions on a new trailer for my 2003 Ranger 519vx. I live on the Texas coast, and it is time to replace my trailer due to rust. I know I can get the trailer...
Type: Posts; User: waterdog242001
Good Morning. I wanted to get some opinions on a new trailer for my 2003 Ranger 519vx. I live on the Texas coast, and it is time to replace my trailer due to rust. I know I can get the trailer...
I installed the same tray on my 2003 519 and would never look back. As others had said, install it as far forward as you can, you will have to cut into your front storage, but it is well worth it. ...
I run a 6" plate on my 03 519 and it runs great.
Got it fixed, debris was on the clogging the hose not allowing water to get to the sensor.
Thanks for the advice. So I am assuming that the analogue gauge and the smartcraft gauge use a different water pressure sensor?
Engine is a 2018 Mercury 200 Pro xs SN: 2B123564 Boat: 2003 Ranger 519 vx
Running the engine yesterday and I got a low water pressure alarm on my smart craft. My analogue water pressure gauge was...
Got it figured out. It was the new compressor leaking from the seal. When I got to the dealership I found out that the lady up front told me the wrong part they replaced. That was the only reason for...
Engine is a 2018 Mercury 200 Pro xs SN: 2B123564
A month or so ago, I was on a fishing trip and lost all engine power the engine would not idle it just shuddered and died every time I started it. ...
I run a 2003 Ranger 519 with a mercury 200 pro xs. I have ran lots of props on that boat, and have found the best prop for overall performance is a Tempest 25 pitch. Fury 3 blade 24 pitch is a...
I can take off with the jackplate all the way up. With my current set up, the butt end of the boat digs and the nose raises. I ran a Bravo 1 xs a week ago and it ran great. I will be most likely...
I have an opportunity to Trade for a Razor XL 23p. If I am running a 25p Tempest 5600 RPM will the 23p Razor XL be enough prop?
for reference boat is a 2003 Ranger 519vx with a 2018 200 hp...
I have a 2003 519vx with a 2018 pro xs, same hull I believe as you are looking at. Boat runs and fishes awesome. My only explination on why it is not a good rough water boat is that the boat fells...
10-4 Thanks for your help on the other post as well. I am going to try the bravo because its available to try. I will at some point contact Mark about a Razor.
I have a 03' 519 with a 2018 200 pro xs 2 stroke. I am looking to get a better hole shot, I have a friend that is letting me borrow a 25.5 brovo 1 XS 25.5 pitch. Does anyone know a good starting...
I'm in.
Thanks guys for all the help. I'm going to check in on the Razor, and my good friend has a Brovo XS that he said I could try.
Thank you guys, how does the Razor 4xl compare to the fury 4 blade in over all performance?
Hey guys I'm looking at trying a new prop to help me get on pad in some shallow water. Before you tell me to idle to deeper water I'll tell you that it is a shallow marsh area in southeast Texas...
I used rivets and Velcro straps about 7 years ago on my boat and never had a problem. I mounted my push pole directly behind the seats.
I think you are pretty close. I have an 03 519 with a 2018 pro xs 200. I am running a 24 fury now with a 6 inch jack plate. 3.5 Prop to Pad Normal load with a partner I am 64-66. Light load I...
I recently re-powered my Ranger 519vx with a 2018 Mercury 200 pro xs 2 stroke sn#2B123564 with 18 hrs. At wide open I am running 5600 RPMs according to my smart craft gauge. I understand that the...
I use the cheapest push pole I found at academy. It breaks down into two pieces that are 6 ft in length. Works for me, but I only use it to get out of areas if I make a mistake. I live in...
I bought some Velcro strips and used a pop rivet to mount them behind the seat. Holds my push pole just fine.
Please keep us updated on how the Fury 4 runs. I am thinking about going to one on my 519.
If you are getting a message that says service 4 wheel drive it is the actuator that shifts the system going out. I had to change mine on a 08 a few years ago fixed the problem. I was having the...