Two things you might look at:
Flex the rod as you check the guides and use a piece of panty hose instead of a Qtip. Pull the spools out of the reel that this happening in and check the spools for...
Type: Posts; User: KSViper
Two things you might look at:
Flex the rod as you check the guides and use a piece of panty hose instead of a Qtip. Pull the spools out of the reel that this happening in and check the spools for...
Still have one and fish it often, but not around pike!
None mentioned are as bad as Carlings consumed in Vietnam after being in a Conex container for months, getting there.
Left handed reel and Aleve!
I have a 7' Klein Quantum Tour, but I believe it is a composite glass/graphite rod. Mine does not have a fore grip. I have several custom rods made by Legit fishing in North Dakota. I love them and...
I would not worry about that. My bet is it's a scratch. That area is supported by the left side cover screws, and I suspect not stressed during use. I'd fish it and enjoy it!
I've been fishing S3's and a tour S3 since a year before they were but on the market. Quantum never made a better reel than the Tour in my opinion. Although the original Smoke is close. I'd like to...
Marinco plug, bow plug, female, typically has a jumper to combine the two 12 volts for 24 output. Hook both the batteries up and check voltage at that plug.
I have a small hub Predator four blade that I typically run in warmer water. The detriment my boat has is a dual 4 bank 15amp charger, 3 group 29 deep cycles and a group 27 cranking battery. Just a...
I just got back from 3 weeks in the Pelican rapids area. Normally spend 10 days up there starting in late May. Then return when Kansas gets too darn hot for 3-4 weeks with the wife. Wish I could talk...
In cool water (68 degrees) with the right chop mine will run 72 on gps with a light load. Same conditions with a tournament load and full live wells last week it ran 65 on the gps. My boat is the...
Trailing edge of the blades were thickened, and cup added to the face of the blade at the trailing edge out to the tip of the blades. My prop had taken a hit on a stump and had slightly bent one...
My prop is a tempest, original series with no plug provisions. Mine runs 6200 at wide open throttle with a little chop on the water. Last time my prop was reconditioned I asked for additional cup to...
Check your jackplate, I had one that sheared one of bolts common to the center section Right hite). I have the same boat and a 95 200XRI. Sounds like you may have a motor issue, me guessing but the...
I have no idea about the product you asked about. I use Mothers CMX from Walmart, $18 or so. A bottle lasts me about two years. I double coat the boat in the spring, apply a coat after 3 weeks on the...
My 1995 188D is wired as Steve described.
I was at that tournament, saw the rock, heard Guido's version of the story. Guido's was a little more descriptive as I recall. Got to spend some time with he and Dion after the tournament, super...
Lost Toby, my 10 year old Brittney, to cancer. 35 years later I still miss him. Remember the good times and let her have peace. We all know your pain.
Scott
Bought one for my spare from Academy Sports
There is a jumper built into the plug on the trolling motor that completes the series connection and provides 24 volts. Good to go on my 95 188, 201 should be the same.
Check out fin and flame on eBay, huge inventory of original Lews parts. If you don't see what you need send him a message.. Super guy to work with.
Do you know if the ramp has been improved? Had a heck of a time getting back on the trailer without falling off the end of the ramp..
Anxious to hear how the trip went as I'm going back to that area in a couple of weeks.
Three coats of Mothers CMX on my 1995 Viper, shines like new and is easy to clean.
I was on North Turtle the first week in June, twice. I won't be going back until they fix the ramp. Not enough water on it to even get off the trailer. Huge hole at the end of the concrete and not...