That’s gonna be a no from me dog..
Type: Posts; User: chriskale
That’s gonna be a no from me dog..
I revisited the test according to instructions provided. It seems I’m 119 to 120 across the board on my gauge so all is well. Thanks
Before someone asks. It’s the port side that’s lower.
0T364621
while doing some maintenance, I decided to check compressions which had always been 125 across the board. Now I have one bank still at 125 and the other at 115. What would cause that...
0t364621
1996 Basscat Jaguar
i assume I over trimmed and upon lowering I heard a pop. Looked back and the pivot plate broke away on both ends. I’ve disassembled and it appears the plastic...
Can’t find a fury 4 24 used and I don’t want to buy new for a backup.. if I go trophy or some other 4 blade, is dropping down to a 24 pitch the route to go? Thanks for the input so far guys...
225 efi motor. I have a 3 blade 25p tempist that works great.. but I need to send it in to get touched up.. which got me thinking that I need a backup prop. Looking for a prop that would work better...
https://ibb.co/f4rz5oTrying to add a picture
Maps and traditional sonar work fine, but I’m getting a very weak return on downvu.. barely recognizes bottom and not picking up any previous marked structure that I used to see.. reset settings,...
Ball game
Agreed
True. But I doubt Lee big eyed his limit
Looks even more likely j lee pulled it off!
As did litner
Update: the horn is buzzing when best I can tell there is no condition. It's a constant tone like overheat but not as loud. Key up tone sounds over it, but this tone is very loud and annoying....
Thank you guys. As luck would have it, I suffered some sort of water restriction this morning and the horn sounded. It sort of faded in volume slightly intermittently, bit it's loud and it works....
Can anyone provide any suggestions as to what to check next? Im afraid to run the boat until I get this resolved..
https://imgur.com/rIntO1R I've attached an image to make sure I've done the right thing. I grounded the tan/Blu directly out of the sensor and just to be sure I grounded tan wire it attaches to. They...
Grounding the tan/blue or the solid tan it connects to did not result in a horn. Water separator horn sounded after 30 seconds. Disconnecting the tan/black at the temp sensor resulted in steady...
Maybe I should add analog gauges..
I've posted year make and model and serial number. I read the requested post and didn't see anything else required, please elaborate?
I get the beep when key on, but would like to test the engine overheat alarm.. what's the easiest way? 0t364621 2001 Merc 225 efi
I found it. I'm an idiot. Thanks for your help. Thankfully it doesn't appear that I screwed anything up. :Fingers crossed.
So then where does the negative battery cable connect to the engine? I thought that was the negative that connects to the bottom of the starter and the positive connected under the plastic shroud...
0T264621
While changing plugs etc, I decided to add redundant grounds from fuel ecu ground since the bolt holding the grounding looked suspect. I used about an 18ga wire from bottom right screw...